What happens if the ignition switch goes out on a Pontiac?
The ignition switch on a Pontiac car Am is responsible for signaling the starter to turn over, which in turn starts the engine. If your Pontiac car Am’s ignition switch goes out, the starter doesn’t know when to engage and the Pontiac car Am will not start.
How to remove the ignition switch in a 1999 Pontiac Trans Am?
Allow the Trans Am to sit for 30 minutes. Lock the steering wheel by pushing it from side to side, then make sure the ignition switch is locked in place as well. Remove the panel below the steering column using the 1/4-inch ratchet and socket.
Where is the electronic ignition switch located on a GM car?
A typical symptom of failure is the security light illuminating on the dash. Also, keep in mind the electronic ignition switch is located just behind the lock cylinder. It is the plastic part that the ignition lock cylinder fits into. It contains the actual electrical connections and wiring and it sends current to numerous different components.
How to remove the ignition switch in a 1999 Pontiac Sunfire?
Turn it to the “Run” position, but do not start the Sunfire. Locate the locking button located on the backside of the ignition cylinder housing. Push the button and then pull the lock cylinder away from the column. Unscrew the ignition switch from the steering column using the Phillips head screwdriver.
Allow the Trans Am to sit for 30 minutes. Lock the steering wheel by pushing it from side to side, then make sure the ignition switch is locked in place as well. Remove the panel below the steering column using the 1/4-inch ratchet and socket.
Turn it to the “Run” position, but do not start the Sunfire. Locate the locking button located on the backside of the ignition cylinder housing. Push the button and then pull the lock cylinder away from the column. Unscrew the ignition switch from the steering column using the Phillips head screwdriver.
Where is the ignition button on a Pontiac?
Locate the locking button located on the backside of the ignition cylinder housing. Push the button and then pull the lock cylinder away from the column. Unscrew the ignition switch from the steering column using the Phillips head screwdriver.
How to replace a no start ignition switch?
GM Ignition switch replacement to fix a no start or intermittent start. Faulty ignition switch contacts can also cause the PassLock system to enable Click here to see step by step proceedures. http://www.thejunkmanadv.com/the-junk… Support the site, buy service manuals here : http://www.tkqlhce.com/click-7357719-… Loading…