What does F1 light mean on cbr 600 F4i?
FI – Fuel Injection You should check the “710” handle on your car engine also. It could give you a problem if things are not running properly there. Looked at my friend’s CBR F4i manual and the FI light has to do with the fuel injection system. Going to take my bike into the shop to get it checked out.
What does FI mean on a motorcycle?
FI stands for Fuel Injection system in motorcycles. There are basically two fuel flow systems first is the most commonly used i.e Carburetor system and the second is the Fuel Injection system. Both have the same function i.e mixing the air and fuel and supplying it to the engine block.
When does the fi light come on on a Honda CBR?
While the engine is running and the motorcycle is being used, the FI light will come on and stay on. When the motorcycle is on its side stand and the is running below 5000 revs the FI light will flash, the pattern of the flashes indicating the code for the fault the ECM has identified.
What does the Mil light on a Honda CBR 600 mean?
All owners of the Honda CBR 600 F4i will sooner or later have to deal with such a problem as the flashing of the FI (MIL) light. These short and not much longer blinks are the same error codes. Each blink carries a certain number, which in turn will tell you about your malfunction.
When does the fault code flash on Honda CBR XX?
If there are no stored codes the FI light will come on and stay on. If there are stored fault codes, the FI light will flash. The fuel injection system warning light uses long ( 1.3 second ) and short ( .5 second ) flashes to give out the fault code.
What’s the failure code for a Honda CBR 600 F4i?
Connection: Yellow/Red (+) – Ground {-) Standard: 4.75-5.25 V Turn the ignition switch to “OFF”. Disconnect the MAP sensor 3P connector. Turn the ignition switch to “ON”. Measure the voltage at the wire harness side connector. Open or short circuit in Yellow/Red wire. Loose or poor contact on the ECM connectors.
What’s the fi light on a Honda CBR 600RR?
Hi i have a 2007 Honda CBR 600RR, i own the bike from last year. The guy who i bought the bike from had put a aftermarket exhaust and power commander. The bike was running fine all year long until the other day the FI light on and HESD. When i turn the key on and bike stand down the FI light one long and 5 short blinks.
How to fix a 2002 CBR 600 F4i that will not start?
2002 CBR 600 F4I will not start. How do I fix it? -Problem: I have a 2002… I have a 2002 CBR 600 F4i that WILL NOT START (No spark or fuel). How do I fix it?
What does the Fi warning light on a Honda CBR XX mean?
If the fuel injection system ( FI ) warning light on the instrument cluster illuminates when the motorcycle is running, a fault has occurred in the fuel injection/ignition system. The engine control module ( ECM ) will store the relevant fault code in its memory and this code can be read as follows using the self-diagnostic mode of the ECM.
When to use code 12 on Honda CBR 600?
When the indicator lights for 1.3 seconds it is equivalent to 10 blinks For example, a 1.3 second illumination and two blinks (0.5 second X 2) of the indicator equals 12 blinks. Follow code 12 on page 5-26. • When more than one failure occurs, the MIL shows the blinks in the order of lowest number to highest number.