What do you cut asbestos siding with?
Answer: You can cut the siding by using either a utility knife or circular saw. Both are pretty easy to work with. If you’ve got an old-style asbestos siding, go for the utility knife or blade paper cutter. And use the circular saw for cutting the newer ones.
Can I cut asbestos shingles?
Also, the siding and roofing can be made friable when it’s being removed. Friable materials can release asbestos fibers into the air. Avoid breaking, sanding, cutting, drilling and sawing the materials.
Can you nail into asbestos siding?
Because it’s better than risking your health. However, if your asbestos siding is in good condition, you can definitely nail into it. Directly putting pressure while nailing into the siding can cause it to break.
How do you cut old siding?
For vinyl shake siding, you can cut panels using snips or a circular saw with a blade that can be used for vinyl. Snips work best for long, vertical cuts while circular vinyl siding saws work best for short, vertical cuts.
Can you put siding on top of asbestos siding?
Some experts recommend screwing, rather than nailing, when new siding is installed over existing asbestos-cement siding. If the shingles are to be removed, they should be wetted during the process to prevent fibers from becoming airborne, and they must be properly disposed of at a landfill.
Can fiber cement siding be cut?
For cutting fiber-cement siding, it’s best to use a 4- to 6-tooth polycrystalline diamond-tipped (PCD) blade made specifically for fiber-cement. Regular carbide blades will cut fiber cement, but they dull relatively quickly, and if you attempt a gang cut, the blades overheat and can warp.
Can you power wash asbestos siding?
Do not power wash your siding. This could release cancer-causing particles into the air which could end up in your lungs.
What do you use to cut siding?
A utility knife is typically the best tool for cutting vinyl siding when you’re making longitudinal cuts along the length of a plank. If you’re only making a few vertical cuts, it’s best to use tin snips or a hand saw. Last but not least, another vinyl siding cutting tool is the circular saw.
How do you cut siding on a ledger board?
Start by using plunge cuts across the top and bottom of the horizontal length of the ledger board, followed by the shorter vertical cuts for the ends using a cold chisel. You will then have to use a claw hammer or a pry bar to remove the nails. For your safety, be careful not to saw through nails.
What’s the best way to cut asbestos siding?
Saw through a cut line in asbestos cement pipe with a hacksaw fitted with a coarse blade. Use slow deliberate strokes with the saw under water trickling from a hose pipe. Cut a 45 degree bevel onto the edge joint of asbestos cement siding with a large carpenter’s rasp.
What kind of siding is made of asbestos?
What is Asbestos Cement Siding? According to Merriam-Webster, Asbestos Cement is: “a hardened mixture of asbestos fibers, portland cement, and water used in relatively thin slabs for shingles, wallboard, and siding”
Is it safe to cut asbestos with a power tool?
Since asbestos dust is a dangerous carcinogen, cutting asbestos cement should be avoided wherever possible. If you have no other choice, avoid using power tools of any kind and wear a respirator equipped with a high-efficiency particulate air (HEPA) filter when doing so.
What’s the best way to remove asbestos from shingles?
A.Cutting or breaking asbestoscement board or shingles releases asbestos fibers into the air. To remove shingles without breaking, apply pressure near the nail head to expose the head enough to cut it off with side-cutters. If at all possible, asbestos shingles should be cut with a shingle cutter.