What causes a car to have a check engine light?
A loose gas cap, failing engine sensors, bad spark plugs, faulty valves such as in the EGR (exhaust gas recirculation) system, or intermittent misfiring could all be potential culprits. In this case, it’s often best to take your car into a mechanic shop to get a diagnostic, or at the very least use an OBD reader yourself.
What to do if your engine light comes on after changing spark plugs?
Or you might have left a wire harness unplugged somewhere. check all harness connections that you touched during the install. also, get a code reader or have autozone or some other parts store pull codes for you to see why the light is on. otherwise, take it to your dealer and they’ll take care of it. You could reset it and see if it comes back on.
Is there a way to turn off the Check Engine light?
Do I need a special tool to turn off my check engine light? Yes. If you want to turn off your check engine light yourself, then you will need an OBD code reader. It plugs into the diagnostic port commonly located under the dashboard in cars made in 1996 or after.
What are the symptoms of bad spark plugs?
Symptoms of bad spark plug wires include a rough idle, a noticeable drop in engine performance, and lower gas mileage. Expect to spend about $50 for a set of plug wires. The mass airflow ( MAF) sensor monitors how much air enters the engine.
What should I do if my check engine light says misfire?
If your “Check Engine” light diagnosis shows a generic cylinder misfire code, you should start with the most likely culprits first. Fortunately, these are also the cheapest and easiest. Spark plugs are as low as $2 each, and can be swapped in about an hour with varying difficulty.
Why does the Check Engine light keep coming on?
I have a 2009 S with 75,000 miles on it and it’s been a great car until October 2013 I have had the car in and out of the shop so many times it’s making me crazy. I’ve spent over $5,000 for different issues and it is still on. Code is P115C Mass Air Flow.
Or you might have left a wire harness unplugged somewhere. check all harness connections that you touched during the install. also, get a code reader or have autozone or some other parts store pull codes for you to see why the light is on. otherwise, take it to your dealer and they’ll take care of it. You could reset it and see if it comes back on.
How do you turn off a check engine light?
If you don’t get a definition, look up the code in the owner’s manual or online. Press the “erase/clear” button on your scanner, then turn off the key and disconnect it. Clearing any codes present will turn off your check engine light temporarily.