What came after the 700R4 transmission?
The 1993 Camaro, Corvette and Typhoon were equipped with the last production 700R4. The last design change of the 700R4 was an added checkball to the valve body. In 1992 electronic controls were added, and it became the 4L60-E.
Does a 700R4 transmission need a computer?
There are no TV cable, mechanical speedometer drive, or governor provisions. To run a 700-R4 trans behind a carbureted engine without a computer, at the very least the TV cable must be hooked up to the carburetor and properly adjusted.
Is a th350 stronger than a 700R4?
According to the big trans guys they are actually stronger than the 700; smaller, lighter, and a better 1st gear ratio. I have had a mildly built 200-4R behind a 462 in a 4000# car for over 10 years with no issues.
How much torque will a 700R4 handle?
I’ve read a stock 700r4 can handle 350 lb-ft of torque. But some were rated higher depending on it’s application. 1989 was not a high horsepower maybe 230 or torque motor if I recall correctly. You could just have that trans freshened up to handle new motor.
Are 700R4 transmissions good?
The 700R4, produced by General Motors/Hydramatic, is considered one of the best overdrive transmissions ever made. This transmission was introduced in 1982 as a replacement for the TH350 transmission, with the primary goal of improving fuel economy .
What’s the difference between the 700R4 and the 4L60E?
The 700R4 and the 4L60E are the same. The only difference is you need a computer to control the 60e. The clutch packs, bands, and steels are all the same. If it’s going in a 3rd gen, you’ll probably want a 4L60E.
What is the weight for a 700R4 transmission?
The 700R4 case is a single piece constructed of cast aluminum. The transmission is 23.4 inches long and weighs 155 pounds. The transmission holds a total of approximately 11 quarts of transmission fluid.
Are all 700R4 transmissions the same?
All 700r4, 4L60, and 4L60E transmissions have the same gear ratios. The major differences are external. Electrical hookups, speed sensor hookups, calibration, and converter stall are the main differences. All of the traditional bellhousing applications (sbc, 4.3,…