What are the tools you need to change your brakes?
The Tools Needed to Change Brakes. 1 Start With the Right Protection. Before you start any project on your car, make sure that you are properly protected. You should have a pair of 2 Brake Pads and Rotors. 3 Jack and Jack Stand. 4 Lug Nut Wrench. 5 Brake Caliper Piston Tool.
What kind of bolts do you need to change brake pads?
Torx / Allen Set. Often the brake caliper bolts are held in place with Torx or Allen bolts. This depends on what your car has installed; therefore, it is better to verify you know what you need to change your brake pads. You can quickly identify what your car uses by looking at the two bolts on the caliper’s back.
How do you replace a brake caliper bracket?
When re-connecting the new calipers, apply Locktite to the mounting threads as well. Be sure to replace the wear sensor when replacing the pads if they appear to be worn. Install the new caliper bracket, and attach the new stabilizer pins. Then, insert the new brake pads, attach the new caliper, and tighten it with the mounting bolts. Figure 7.
What do you need to change brake pads and rotors?
What Tools Do You Need To Change Brake Pads and Rotors? – YOUCANIC What Tools Do You Need To Change Brake Pads and Rotors?
What kind of tool do I need to remove brake bolts?
Some calipers may require a hex-head (also known as “Allen head”) socket or Torx head socket to remove the bolts. A caliper piston compression tool will push a piston back into its housing to provide clearance for new brake pads.
What are special tools used in Brake Service?
Either way, a specially shaped brake bleeder wrench makes it easy to open and close bleeder valves on each caliper. Some examples we offer are the OEM Tools One Person Brake Bleeder Kit, CTA One Man Brake Bleeder Kit, and the Powerbuilt One-Man Brake Bleeder Master Kit just to name a few.
How do you replace disc brakes on a car?
On some rear disc brakes, the caliper pistons screw in, and require the disc brake pad spreader set to be seated properly. Take the caliper off the bungee cord and put it back on. VERY IMPORTANT – DO NOT OVERTIGHTEN the caliper bolts.