Is there a way to disable anti theft system?
The annoying problems that the anti theft systems cause are commonly known. Most people report an anti theft system getting activated when there are no potential threats around, i.e., it is liable to produce a false alarm. If that is an issue you are facing, refer to how to disable anti theft system, for a hassle-free drive experience.
How can I disable the pass lock system?
•Avoid Costly repairs for an already broken PassLock System. •Disable Pass Lock system to prevent from being stranded in the future. This tutorial varies depending if the ignition is located: If your ignition is located in the dash then you will be removing the panels on the passenger underside (toe board) of the dash.
How to bypass vats, Passkey and PassLock security systems in GM?
It can be VATS, Passkey or Passlock anti theft system that is going bad causing your issue. I am going to share a secrete with you on how you can bypass these systems with very little effort. This is a really unique security system bypass kit that you can use to override your current factory theft system on your GM vehicle.
How is the anti theft system supposed to work?
The anti-theft Light is meant to flash and blink periodically in order to show that the system is engaged. Sometimes the blinking light scares the thief as well. However, car owners must remember to lock the automobile’s doors for the alarm to be active. How do you reset theft deterrent?
What to do if your anti theft system is locked up?
If the anti-theft system has locked up your engine, you won’t be able to start it. You’ll have to disable it with these steps. Step 1: Check for the anti-theft light. It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position.
How to turn off the GM PassLock anti-theft system?
The switch in question is a fail close switch meaning when the door is opened it completes a circuit. Simply use a torx wrench and remove the drivers door switch and unplug. Replace the unplugged switch back into the hole and you are good to go. My Hummer has been starting ever since.
•Avoid Costly repairs for an already broken PassLock System. •Disable Pass Lock system to prevent from being stranded in the future. This tutorial varies depending if the ignition is located: If your ignition is located in the dash then you will be removing the panels on the passenger underside (toe board) of the dash.
How to disable the anti theft device in your car?
Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder. Tip: Try turning the key both ways fully to disable the anti-theft system.