Is it hard to fix a water pump?
While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.
How long does it take to fix water pump?
On average, water pump replacement is a 3 hour job. You may pay less if you buy the pump yourself and give it to the mechanic to install, though use caution and make sure to buy the parts from a reputable source.
How much is a water pump for 2008 Corolla?
2008 Toyota Corolla Water Pump – from $43.99+ | AutoZone.com.
How to replace the water pump in a corolla?
Especially if one is due for coolant replacement anyway. 1. Loosen the bolt that holds the crankshaft pulley. Raise the front of the car, put it on jackstands. Remove the passenger front wheel, remove the splash guard. Get a 17mm socket with a long ratchet. Like two feet. You will need all the torque you can find. Or an air impact gun.
How do you remove timing belt from corolla?
Removing the middle and lower cover is a bit of a pain. Mostly because the middle cover has to be wiggled out from behind the water pump pulleys. Work the middle and lower cover together to get them off. The rubber plug in the lower cover hides the bolt that holds the timing belt tensioner.
Do you need to change the timing belt on a water pump?
Meaning that as far as timing belt is concerned, the mandatory items are the belt itself and its tensioner. The water pump is driven by an external accessory belt. No need to change the water pump along with timing belt to ensure the belt’s safety. But, in order to change the water pump, the
What should I do when I change my water pump?
When changing the water pump, there are a few ways to handle coolant. If you are certain that the bolt for draining the engine block is not going to snap, then drain the block. In other case (the more probable one) one can just let the coolant flow out when the pump is disconnected from the block and the head.