Is a Turbo 350 the same length as a 700R4?
Length And Weight The TH350’s case length is 21 5/8 inches. Depending on the tail shaft housing, its overall length can either be 27 5/8 or 30 5/8 inches. The 700R4’s case length is 23 3/8 inches and its overall length is 30 3/8 inches. The TH350 weighs 120 lbs., while the 700R4 weighs 155 lbs.
Will a 700R4 fit in place of a TH350?
Re: Replace a TH350 with a 700R4? The 700R4 will bolt up to your small block v-8. You’ll have to move the trans crossmember back a few inches and drill new holes to bolt it down.
What is the length of a 700R4?
Chapter 2: Transmissions: Transmission Lengths
| Transmission | Case to ext. Housing | Overall Length |
|---|---|---|
| THM 400 (long tail) | 24 3/8″ | 34″ |
| THM 200-4R | N/A | 27 3/4″ |
| THM 700R4, 4L60, 4L60E | 23 3/8″ | 30 3/4″ |
| THM 4L80E | 26 1/16″ | 32 3/16″ |
Does a 700R4 have a kickdown cable?
The TV cable on the 700R4 and 200-4R transmissions controls line pressure, shift points, shift feel, part throttle downshifts, and detent (full throttle) downshifts. One component that helps both drive systems communicate is the kickdown cable. …
How much power can a stock Turbo 350 handle?
The Stage 1 TH350 is rated up to 450 hp. Those seeking something a little stronger can check out the Stage 2 version (PN PA35102) that holds 550 hp and retails for $1,500 with a real world street price of $1,175 from most vendors.
Is the 700R4 transmission any good?
Its lower first gear ratio provides excellent performance for low vehicle speeds. Besides, a 30% overdrive brings about enhanced fuel economy, a reason that can also be attributed to the popularity of the 700R4. The torque that can be handled by a 700R4 transmission varies depending on its production year.
Is the 700R4 the same length as the turbo400?
I plan to put a 6.5 turbo diesel in it and would like to use a 700R4 because of the axle gear ratio. It has a New Process 208 transfer case. My question is are the turbo400 and the 700R4 the same length from the engine to the transfer case mount.
What’s the difference between a 700R4 and a TH350?
Length – The TH350 is a shorter than the 700R4, so if you were going to swap one for the other, you’d need to have your driveshaft resized or replaced. Gear Ratios – The TH350’s gears are placed closer together (despite having less of them).
What is the length of a 700R4 transmission?
Depending on the tail shaft housing, its overall length can either be 27 5/8 or 30 5/8 inches. The 700R4’s case length is 23 3/8 inches and its overall length is 30 3/8 inches.
Can a 700R4 be swapped for a 350?
B&M and TCI both sell 700R4 upgrade kits capable of handling over 450 foot-pounds of torque. If your original TH350 came with a 6-inch tail shaft, you’ll have to cut the drive shaft by 3 inches. If your old transmission had a 9-inch tail shaft, then the drive shaft should fit.