How to unlock the trunk of a Mercedes Benz?
To unlock the trunk manually: while inserting the key push the lock in and turn it to the left about 1/4 turn. Key needs to remain in the lock. Try this a few times, it should release. It may also release easier if your car is unlocked… the doors that is.
What to do if your Mercedes Benz key fob is not working?
1. Put the key in the ignition. 2. Quickly remove it within 10 seconds and hold down the Lock button. 3. While holding the Lock button, press Unlock five times. 4. Release these buttons and press the Trunk button once.
Why is the trunk on my Mercedes not opening?
I have no light on the power trunk switch (nothing happens when trying to open it) and the remote does not open it. It all started when the battery died. To make thinks worse, the key blade only goes in 1/4 of the way even after lubricating it a few times.
What kind of key is in the trunk of a Mercedes?
I locked the primary electronic key (the one with the internal manual key blade) in the trunk of my 1998 Mercedes Benz E320. The car was unlocked, but my trunk release switch on the center console did not work. I looked for solutions on the Internet and tried the “bottom two fuses removal” and “remove rear seat back” methods, to no avail.
What should I do if my Mercedes key fob is not working?
If you need a replacement battery note that Mercedes-Benz uses CR2025 battery type. Ensure you have new batteries in your key fob. Next, look carefully at your Mercedes-Benz key. When you press the button on your key you should see a small RED led light. The light should light up every time you press any of the buttons (Lock, Unlock, Panic, Trunk).
How do you unlock the trunk of a Mercedes Benz?
Connect a jump box positive terminal to the positive terminal and the negative jumper cable to a ground point or frame. Alternativly instead of a jumper cable Now you can press the Lock/Unlock buttons on your Mercedes-Benz key fob remote to unlock the car or the trunk.
How do you program a Mercedes fob remote?
There are a few cases when you need to program your key fob remote to your Mercedes-Benz. Below you will find general instructions on how to synchronize a Mercedes key fob. For model specific instruction check your owner’s manual. Insert the key into the ignition. Quickly remove key from ignition and within 10 seconds hold down the lock button.
Why is the panic button on my Mercedes not working?
The panic button and/or trunk unlock features don’t work. Your problem is likely that the fob can start the car but will not allow you to unlock the vehicle’s doors or trunk. In other words, it will not allow you to use the fob as a keyless entry remote. Here are some common reasons for this issue: 1. The key is defective.