How to remove the governor for a 50cc Honda Metro scooter?

How to remove the governor for a 50cc Honda Metro scooter?

Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.

How do you remove Governor from Honda variator?

Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.

How do you remove Kickstart from Honda Metro scooter?

Pulling it will allow you to remove the kickstart from the side of your scooter. Remove the intake case from its position above the variator case. The intake case is held in place by three bolts that can be unscrewed with a standard socket wrench. Removing the case will give you more space to work with the variator system.

How to remove the part that limits speed on a 150cc scooter?

Pull the small washer from around the front pulley bar upon removing the outside of the front pulley wheel. This washer limits the speed of your 150cc scooter. Put the front pulley wheel back onto the pulley rod, replace the variator case cover and the intake case, and put the kickstand back on the scooter.

What causes a scooter to have power but not start?

Check the Engine Ignition and Fuel System: In most cases, the problem with a scooter not starting but with power is caused by an issue with the engine; either a bad spark plug wire, bad plug or a fuel system problem.

Why are my turn signals on my scooter not working?

Turn signals do not work correctly. Occasionally one turn signal may not work or they both may come on at the same time. Solution: There is a loose or disconnected wire under the front cowl. Remove the cowl and check the connections from the turn signals to the wiring harness. Most likely, a connector is loose.

What should the voltage be on my scooter?

It should be somewhere in the region of around 10 or 20 ohms. If it’s an open circuit, it’s burned out and will need to be replaced. If it seems to be OK it may be stuck, or the wiring to it may have a problem. Check to see that it’s getting voltage.

Is the Honda Scooter still the friendliest car?

The scooter has come of age. And in this climate of high gas prices, not a moment too soon. For almost half a century, Honda has been committed to making transportation powerful, dependable, sophisticated, and, above all else, fun. Find out why you still meet the friendliest people on a Honda.