How to remove CV axle on Arctic Cat 650?
On our Arctic Cat 650, we needed to remove the cotter pin and axle nut first before trying to remove the wheel hub. The next step is to pull the hub off and unbolt the Knuckle assembly. There are two bolts, one on top and one on bottom. This allows the knuckle to pull out toward you.
How do you replace an axle on an Arctic Cat?
The knuckle on this Arctic Cat has two bolts holding it in place. Reach for the new axle assembly and make sure to add a little differential oil or grease to the seal before reinstalling the new axle into the transmission.
How do you remove a CV axle from an ATV?
Using a dead blow or rubber hammer ensures that you don’t scar up the threads or anything else. Remove the remaining axle by pulling it straight out from the side. The axle can be coaxed from its fixture by simply tugging on the end closest to the wheel. This may take a few tries to be successful, but it will come out.
Where is the spring clip on a CV axle?
The axle spline on the differential end has a spring clip that holds the axle in the housing. Lubricating the surface of the axle cup prevents scarring of the seal when reinstalling the new CV half shaft. Be careful when handling the axles as just a small ding or dent in the dust cover can create future problems.
On our Arctic Cat 650, we needed to remove the cotter pin and axle nut first before trying to remove the wheel hub. The next step is to pull the hub off and unbolt the Knuckle assembly. There are two bolts, one on top and one on bottom. This allows the knuckle to pull out toward you.
The knuckle on this Arctic Cat has two bolts holding it in place. Reach for the new axle assembly and make sure to add a little differential oil or grease to the seal before reinstalling the new axle into the transmission.
Can a CV axle be reinstalled on an ATV?
Lubricating the surface of the axle cup prevents scarring of the seal when reinstalling the new CV half shaft. Be careful when handling the axles as just a small ding or dent in the dust cover can create future problems. Our new axle fit right in perfectly.
The axle spline on the differential end has a spring clip that holds the axle in the housing. Lubricating the surface of the axle cup prevents scarring of the seal when reinstalling the new CV half shaft. Be careful when handling the axles as just a small ding or dent in the dust cover can create future problems.