How to remove and install a Nissan Rogue?
Use two people when removing or installing the front door due to its heavy weight. When removing and installing front door assembly, support front door with a suitable tool. Remove front door finisher. Refer to INT-15, “Removal and Installation”. Remove front door vapor barrier (1). NOTE: LH side shown; RH similar.
What are the problems with the Nissan Rogue?
Rear differential bolts were loose causing a loud bang occasionally from the rear. Bolts were torqued to spec and no further noises. Grinding/Chain dragging on ground sound when driving at low speeds. Gear shift stuck Exact same problems as before…gear shift is stuck have to use a pin.
Why do I need to replace my transmission on my Nissan Rogue?
CVT Transmission was replaced, due to inherant manufacturer defect. The new replacement part was an upgraded, newly designed CVT transmission. Front passenger-side CV Joint boot was torn, grease found to have leaked out. Dealer recommended replacing entire axle.
How to adjust front door height on Nissan Rogue?
Loosen front door hinge nuts (door side). Adjust the surface height of front door according to the specifications provided. Temporarily tighten front door hinge nuts (door side). Loosen front door hinge bolts (body side). Raise front door at rear end to adjust clearance of the front door according to the specifications provided.
How many people to remove Nissan Rogue Hood?
Use two people when removing or installing hood assembly due to its heavy weight. Use protective tape or shop cloths to protect surrounding components from damage during removal and installation of hood assembly.
What should I use to protect my Nissan Rogue?
Use protective tape or shop cloths to protect surrounding components from damage during removal and installation of hood assembly. Support the hood assembly using a suitable tool. WARNING: Bodily injury may occur if hood assembly is not supported properly when removing hood assembly.