How to install a new brake on a Pontiac Firebird?
Install a new cotter pin and bend the ends around the nut. Place the dust cap square on the spindle bore and use a hammer to lightly tap it around the circumference until the cap sits flush against the rotor. Install a brake caliper rubber hose line and retainer spring clip. Install the caliper. Line up the caliper with the bracket.
Where is the retainer ring on a Pontiac Firebird?
Use a 3/8-inch line wrench to remove the short section of rubber brake line from the steel brake line at the bracket. A retainer ring is located at the back side of the brake line bracket. Use a flat-head screwdriver or pick to snag it and lift it out. A dust cap is at the center of the brake rotor.
Where are the caliper pins on a Pontiac Firebird?
To do that, locate the caliper pins on the back side of the caliper. To gain easier access to the caliper pins, turn the steering so the rear is pointing outward. Use a 3/8-inch Allen socket on a 3/8- or 1/2-inch ratchet to loosen the upper and lower caliper pins.
How do you replace a wheel bearing on a Pontiac Firebird?
Install a new wheel bearing after packing grease into the bearing orifices. Use a ball-peen or other suitable hammer to gently tap the new grease seal into position on the back side of the rotor. Inspect the rotor and make sure the rotor is true and there is no damage or flaws. Slide it onto hub.
Install a new cotter pin and bend the ends around the nut. Place the dust cap square on the spindle bore and use a hammer to lightly tap it around the circumference until the cap sits flush against the rotor. Install a brake caliper rubber hose line and retainer spring clip. Install the caliper. Line up the caliper with the bracket.
How much does a Firebird rear drum brake cost?
1967 – 1979 Rear Drum Brake Backing Plate Bolt-In Studs 2pc. Our Price: $16.95 Our Price: $16.95 Our Price: $16.95 Our Price: $16.95
Use a 3/8-inch line wrench to remove the short section of rubber brake line from the steel brake line at the bracket. A retainer ring is located at the back side of the brake line bracket. Use a flat-head screwdriver or pick to snag it and lift it out. A dust cap is at the center of the brake rotor.
When did the rear disc brake come out on the Trans Am?
The rear disc brake option was offered as part of the WS6 Special Performance Package starting in 1979, which helped the stopping power even more. This Tech Tip is From the Full Book, TRANS AM & FIREBIRD RESTORATION: 1970-1/2 – 1981. For a comprehensive guide on this entire subject you can visit this link:
Which is the best way to install Firebird?
Although it is possible to install Firebird by a filesystem copying method – such as “untarring” a snapshot build or decompressing a structured .zip archive – it is strongly recommended that you use the distributed release kit (.exe for Windows, .rpm for Linux), especially if this is the first time you install Firebird.
How do you replace the brake shoe on a Camaro Firebird?
Brake shoe removal. To lubricate the star adjuster, work the brake lever on the backside of the backing plate back and forth, then push out the tappets. Remove the tappets and pin. Clean all components in brake parts cleaner and lubricate at points 1, 2, and 3 with a silicone-based grease before reassembling.
Install a new wheel bearing after packing grease into the bearing orifices. Use a ball-peen or other suitable hammer to gently tap the new grease seal into position on the back side of the rotor. Inspect the rotor and make sure the rotor is true and there is no damage or flaws. Slide it onto hub.