How to do an oil change on a Roadstar?
One by the kickstand, and the other on the bottom of the oil tank. When doing a proper oil change including filter, just put 4 quarts back. Put two in, and replace the dipstick and screw it in. Start the bike, and let it run for about 10 seconds or so. Shut the bike off, and add the other two quarts. Button it up and forget about it.
What causes front pulley nut on Roadstar 99-05 to back off?
The front pulley nut on the R*’s are known to back off from reverse torque. The 99 – 05 models have a tab washer that has one tab bent over the nut. It doesn’t hold very well and the nut can back off.
What kind of washer does a 99-05 Roadstar have?
The 99 – 05 models have a tab washer that has one tab bent over the nut. It doesn’t hold very well and the nut can back off. The 06 and newer they did away with the tab washer and put a conical washer under the nut and changed the nut to have a flange that is staked into a channel on the shaft.
What’s the difference between a Roadstar 06 and 06?
The 06 and newer they did away with the tab washer and put a conical washer under the nut and changed the nut to have a flange that is staked into a channel on the shaft. It is also found not to hold very well on some but is better than the older tabbed version.
One by the kickstand, and the other on the bottom of the oil tank. When doing a proper oil change including filter, just put 4 quarts back. Put two in, and replace the dipstick and screw it in. Start the bike, and let it run for about 10 seconds or so. Shut the bike off, and add the other two quarts. Button it up and forget about it.
How does the oil pump work on a Yamaha Roadstar?
The oil pump has two gears (inner and outer). When the two gears rotate, the intake area separates and creates a vacuum between the gears. This vacuum sucks oil, which is later transferred to the discharge area through gear motion. Afterward, the gears connect (on the discharge side) to squeeze the oil out.
Are there any problems with the Yamaha xv1600 Roadstar?
This problem is quite serious, as the rear wheel may seize, increasing the rider’s chances of crashing. Yamaha issued a recall for this problem, instructing dealers to make necessary modifications to the transmission by replacing the transmission gears and shafts with adequately machined parts.
The 99 – 05 models have a tab washer that has one tab bent over the nut. It doesn’t hold very well and the nut can back off. The 06 and newer they did away with the tab washer and put a conical washer under the nut and changed the nut to have a flange that is staked into a channel on the shaft.
How much oil does a road Star have?
The Road Star holds a TOTAL of 5 Litres/5.3 US Quarts of oil, but you don’t use that much unless you strip the engine down. · What mileage can I expect?
The oil pump has two gears (inner and outer). When the two gears rotate, the intake area separates and creates a vacuum between the gears. This vacuum sucks oil, which is later transferred to the discharge area through gear motion. Afterward, the gears connect (on the discharge side) to squeeze the oil out.