How to check fuel pressure with ECM command?
Pressure Check – With your scan tool set to show ECM-commanded fuel pressure and actual fuel pressure, perhaps a couple other key items, such as engine rpm, fuel temperature, or fuel level. Check for fuel pressure readings at different times – with KOEO (Key On Engine Off), while cranking, at engine idle, or under load.
What to do if your ECM is not working?
If your car seems to run fine but the Check Engine light won’t turn off, your ECM may be at fault. The only way to be sure is to visit a mechanic with the proper computer. They can analyze your vehicle’s error codes, and let you know exactly what the problem is.
How does the engine control module ( ECM ) work?
The ECM takes the information from the engine’s various sensors, and uses that information to calculate and tune engine spark and fuel for maximum power and efficiency. The ECM plays a crucial role in newer vehicles, where many (if not all) of the essential functions of the car are controlled by the ECM.
How does a bad ECM affect fuel economy?
Poor Fuel Economy. A faulty ECM disallows your engine from knowing how much fuel to burn in the combustion process. Typically, the vehicle consumes more fuel than it should in this situation. You’ll end up paying more for gas than you would with a functioning ECM. The ECM plays a vital role in engine performance.
If your car seems to run fine but the Check Engine light won’t turn off, your ECM may be at fault. The only way to be sure is to visit a mechanic with the proper computer. They can analyze your vehicle’s error codes, and let you know exactly what the problem is.
What does the code p0125 on the ECM mean?
The ECM monitors engine coolant temperature through a sensor after start-up. If no information is coming from the sensor after the engine is warmed up, this will trigger the code P0125. Possible causes include low coolant, stuck or bad thermostat, or faulty sensor.
Why does my ECM say fuel to air?
Your engine is never as finicky about fuel-to-air ratio as it is when it’s first starting up. If your ECM is setting the ratio incorrectly, this is the first time you’ll notice.
What does it mean when your ECM says p0600?
Here are a few of the most common: The P0600 Code: This code means that there’s a problem with one of the sensors connected to your ECM. Alternatively, it may just indicate a wiring error. The P0700 Code: This code means that there’s an error with your TCM.