How to change the brake pads on a Mercedes ML320?

Install the caliper. Tighten the two bolts in the back of the caliper to 23 Nm. Reinstall the rest in reverse order. Remember to put back the cap on the brake fluid reservoir. Start the car but do not drive yet. Press the brake pedal a couple of times until the pedal feels hard to press. VIDEO: How to change rear brake pads on ML320 1998-2005.

How to install new brake pads on a Mercedes medic?

Install the locking bolt and tighten to 23 Nm. Install new brake pads on the calipers. First you will need to install the inner brake pad into the piston. Then install the outer brake bad. Make sure to clean the surfaces where the brake pads slide. You will need to press the cylinder in the caliper.

How to replace rear brake pads and rotors?

Step-by-step instructions on how to replace the rear brake pads and rotors on any Mercedes Benz ML320 ML430 ML350 ML500 years 1998-2005 If this is your first time doing this job plan on spending around 4 hours. Makre sure you have all your tools and parts ready. We would strongly recommend that you install ceramic brake pads and new rotors.

How do you install a new brake pad?

Install new brake pads on the calipers. First you will need to install the inner brake pad into the piston. Then install the outer brake bad. Make sure to clean the surfaces where the brake pads slide. You will need to press the cylinder in the caliper. You will need a caliper press for this, we have found that Lang Caliper Press Tool works great.

Where are the brake pads on a Mercedes?

Brake pads sit on either side of the brake rotor and clamp onto the rotor when you apply your brakes, causing your car to slow down and eventually stop.

How long is the warranty on Mercedes brake pads?

Mercedes brake pads and our other genuine discount parts come with a three-year or 36-month warranty. A toll-free customer hotline, where you can ask questions or even place orders. Visit our Contact Page for more information.

How to remove and install front brake pads?

Unscrew the cap from the brake fluid reservoir. Jack up the car and remove the wheel that you will be working on. Make sure to secure the car with jack stands. Inspect: Check brake pad thickness and condition of rotors. Check for brake fluid leaks. Check dust seals for damage. Remove brake pad wear sensor connector.

When to replace front brake pads and rotors?

Years: 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005. Genuine OEM Mercedes-Benz Front Rotors. Check fitment. Before you start replacing parts it is a good idea to inspect the condition of the pads and rotors. While brake pads are easy to inspect, rotors require that you measure the thickness of the disk to see if it is within limits or not.

How much does it cost to change brake pads on a Mercedes?

The typical cost to change Mercedes-Benz rear brake pads yourself averages $100. The average cost to change the brake pads at an auto mechanic or dealer range between $250 and $500. If you plan to replace the rotors, the cost would be two to three times more than just changing the brake pads.

Where do you put the brake spreader on a Mercedes?

If your Mercedes-Benz has electronic parking brakes, you will need to place the rear brakes in service position via the instrument cluster. If you don’t have a brake spreader, use a flat head screwdriver to push the piston in, as shown in the picture below.

What kind of tools do you need to repair a Mercedes Benz?

7 Tools You Must Have for Mercedes-Benz DIY Repair Mercedes-Benz Offset Engine Mount Tool Radio / Cluster Removal Tool Mercedes Benz Transmission Fluid Dipstick Spark Plug Wire Puller Removal Tool Oil Filter Removal Tool E-Torx Socket Set Diagnostic Scanner

What should the torque be on a Mercedes brake pad?

The typical torque range is between 30 and 55 Nm and varies between models. Call your dealer to get the recommended torque specifications for your Mercedes-Benz. Connect the brake pad wear sensor.

Can a Mercedes-Benz ml-500 brake pad be replaced?

Mercedes-Benz ML-500 easy brake pad replacement. If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

Can you watch Mercedes Benz brake pads on YouTube?

(Playback ID: OWJiiftES8HqWgT6) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later.

How do you remove a disc rotor from a car?

1. Remove rear tires with power tool. 2. Remove disc rotor. See: Brake Caliper > Removal and Replacement > Removal And Installation. Parking brake completely in the released position. 3. If disc rotor cannot be removed, remove as follows:

When to replace rotors and brake pads in Mercedes?

The first set of rotors usually last through one set of brake pads before there is a need for replacement. However it may not be uncommon for both Mercedes rotors and brake pads to be replaced at the same time. Usually prior to replacement, it is recommended to have them measured.

Is it normal for a Mercedes rotor to hang up?

If driven regularly and no brake pulsation is noticed, the rotor displaying scoring or grooves is normal. This is especially the case if the brakes are not making noise nor are they pulsating. If there is some or lot of discoloration in the Mercedes rotor, the caliper may be hanging up.

What causes a Mercedes brake caliper to hang up?

If there is some or lot of discoloration in the Mercedes rotor, the caliper may be hanging up. If this is the case, one side of the brake pads may wear out faster than the other. The car may possibly pull to the left or right when stepping off the gas.

What are the front wheel bearings on a 2001 ML320?

MY 2001, ML320. Has anyone changed the front wheel bearings? Is this a DIY job? I thought it was the brake pads wearing on the rotor, but I removed the caliper and spun the rotor and heard and felt a faint “thump thump thump” from the rotor area.

How long does it take to replace brake line on Mercedes 99 ML?

JAD, about 6 mos. ago I replaced an entire left rear brake line on a 99 ML, and from start to finish it took approx 1 hr. 15 mins. There was no raising of the chassis necessary.

How can I remove wet rotor from MB medic?

Pull out the brake caliper with the pads. Remove the two bolts shown below. Remove the bolt that keeps the rotor centered. At this point you should be able to remove the rotor. You may want to spray a WD-40 a few times and let the sit for a while. See the wet rotor above?

How to change rear brake discs and brake pads on Peugeot?

Learn from our experts in car part replacement. An error occurred while retrieving sharing information. Please try again later. All auto parts at low prices!

Navigation