How to change General Motors RWD rear axle bearings?
How to Change General Motors RWD Rear Axle Bearings 1. Park on a flat and level surface and leave the parking brake off. Block both the front and rear of one (or both)… 2. Shift the transmission into neutral. 3. Slide the drain pan under the differential. Remove the bolts securing the cover to …
What to do when rear axle bearings fall out?
Look inside the carrier in the opening left by the pin removed above at the axle ends and remove the clips. If a clip is missing, check the bottom of the differential housing. It probably fell out when you pushed the axles inward. If you’re only replacing one bearing, only push inward on that axle.
How are the axles secured to the differential?
The axles are secured inside the differential by a C-clip. Look inside the carrier in the opening left by the pin removed above at the axle ends and remove the clips. If a clip is missing, check the bottom of the differential housing. It probably fell out when you pushed the axles inward.
When does a CV axle need to be replaced?
A CV axle is needed when a vehicle has an independent suspension on drive wheels. In an independent suspension, the left and right wheels move up and down following the road surface independently of each other.
Can a front wheel drive axle be replaced?
Balls and grooves will show wear before the joint fails completely. Replacing a front-wheel-drive axle is straightforward, although physically demanding. Get the replacement axle before you start, as well as a new spindle nut and a cotter pin or two.
How do you replace a CV axle in a rear drive vehicle?
Step 1: This is a rear drive vehicle with two CV joint axles. Start by disconnecting the battery, jacking up the vehicle and allowing some penetrating oil to soak into any retaining bolts.
What should I do if my front drive axle fails?
A failed boot requires immediate disassembly and cleaning, fresh lube and a new boot. This joint shows minor wear. Balls and grooves will show wear before the joint fails completely. Replacing a front-wheel-drive axle is straightforward, although physically demanding.
Which is the right side of the axle to replace?
And it’s usually the right side that goes first because here in the lefthand-drive US of A, we turn sharper around righthand corners than lefthand ones. Sometimes the rubber boots covering the joints fail from age or are torn by road debris, letting the grease out and dirt and water in.