How many oxygen sensors are on a 2006 jeep commander?
Set of 4 New Oxygen O2 Sensor for 2006-2010 Jeep Commander V6 3.7L V8 4.7L 5.7L | eBay.
Where is the oxygen sensor on a 2006 jeep commander?
The sensor is located right off the exhaust manifold just before the mini-cat on the passenger side of the vehicle.
How many o2 sensors are on a Jeep Commander?
Oxygen sensors are located before and after the catalytic converter. A vehicle may have two to five oxygen sensors, and sometimes even more.
How do you replace an oxygen sensor on a jeep?
Built for use with ratchets and breakers bars, the TEKTON 47749 Offset Oxygen Sensor Socket makes removing and installing oxygen sensors on vehicles with computer-controlled engines easy. A heat treated, For drivers side you pretty much need to remove the inner fender well to access the plug.
What kind of engine does a Jeep Commander have?
This vehicle has the 4.7 engine with the automatic trans. Currently 130,000 miles on the odometer. I have owned this Jeep since new. This is an intermittent problem that has been going on for a few months. There doesn’t seem to be anything unusual in the way the tranny shifts.
What should the temp be on a Jeep Commander?
In one thread a forum member said he purchased an infra-red heat sensor and shot it at the tranny when the light came on, only to find that the temp on the tranny pan was 180 degrees. If the tranny was overheating, would it show on the tranny pan temp with a infra-red sensor, or would this temp be cooler than the inside of the tranny?
Is there anything wrong with my Jeep Commander?
The Jeep is back from the tranny shop, and the mechanic said he can’t justify doing anything at this point, as the codes don’t tell him anything specific that is wrong with the tranny, and the filters, and fluid, which he did change, looked good. Also said there is nothing he can find wrong with the torque converter.