How is the gas pedal connected to the throttle body?
Many car makers including GM started installing fly by wire electronic throttle bodies. In those vehicles, the “gas” pedal isn’t connected to the throttle body by a cable. The pedal simply provides an electronic signal, telling the throttle body how much acceleration you’re requesting.
What’s the throttle body relearn procedure for a Saturn?
Start engine and ensure the engine speed is between 450 to 4,000 RPM. 2. Check that manifold absolute pressure (MAP) is greater than 5 kPa. 3. Check that the mass air flow (MAF) is reading is greater than 2 g/s. 4. Check that the ignition 1 voltage is greater than 10 volts. 5. Idle the engine in PARK for 3 minutes. 6.
What happens when you replace the throttle body?
If you replace the throttle body, the PCM won’t know and will continue to use the adaptive settings as if the carbon buildup is still in place. If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle.
How long does it take for GM throttle body to relearn?
If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle. It will eventually learn it on its own, but it may take over a week of driving, during which time you will experience high and low idle speeds and possibly rough idle. 1) Start the engine and let it idle in park for 3 minutes.
Start engine and ensure the engine speed is between 450 to 4,000 RPM. 2. Check that manifold absolute pressure (MAP) is greater than 5 kPa. 3. Check that the mass air flow (MAF) is reading is greater than 2 g/s. 4. Check that the ignition 1 voltage is greater than 10 volts. 5. Idle the engine in PARK for 3 minutes. 6.
Many car makers including GM started installing fly by wire electronic throttle bodies. In those vehicles, the “gas” pedal isn’t connected to the throttle body by a cable. The pedal simply provides an electronic signal, telling the throttle body how much acceleration you’re requesting.
How to do throttle body re-Learn Chevy Malibu?
1) Start the engine and let it idle in park for 3 minutes. During that period the idle may be higher idle than normal. 2) After 3 minutes, turn the engine off and leave it off for 60- seconds. 3) Start the engine again and let it idle in park for 3 minutes one more time. During these run periods you may see a check engine light.
How to reset throttle body calibration [ step by step guide ]?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
Can a car stall with a bad throttle position sensor?
The engine can stall for no reason and without any warning. This happens when the TPS gives incorrect information to the ECM. The engine can stall at high speed, at low speed, or even at idle. A faulty throttle position sensor will not let your car accelerate normally. Though this doesn’t happen all the time.
Why does my car stall immediately after starting?
Rarely I have to rev at stops or the idle drops too low and stalls. If I punch the gas very quickly it revs and drops quickly and then stalls. Starting has a success rate of about 50% without revving. If it stalls, I must rev the engine to start.