How does a bi-xenon Head Light Work?
In order to get both the main beam and dipped beam in one bulb, reflectors may be added to the headlight. When the driver switches between main and dipped beam headlights, the reflectors adjust the angle of the light. Some bi-xenon headlights use shields instead of reflectors. These shields block light when dipped beams are in use.
Do you need to adjust your xenon headlights?
Some vehicles might not need adjusting at all. Some OEM (Factory Fitted) Xenon headlightsare completely flat and will not cause any hazard to oncoming traffic no matter what country you are in. You would have to check your vehicle hand book to confirm this or contact your dealership directly.
Can a xenon light be used as a dipped beam?
Well, we have to remember that xenon bulbs are extremely bright. In fact, they can blind drivers ahead of you or oncoming traffic if not properly installed. In a standard xenon headlight, xenon bulbs are typically used only for the dipped beam, or low beam, headlight to avoid this potential danger.
What’s the best way to adjust adaptive bi-xenon?
Cover up one of the headlights so you can clearly see the uncovered headlight’s beam (makes things easier this way). Insert the screwdriver and begin turning SLOWLY. I cannot stress this point enough – it doesn’t take many turns, so be slow! Once done, swap sides. Most manufacturers recommend a 1.5° downward angle for headlights.
Cover up one of the headlights so you can clearly see the uncovered headlight’s beam (makes things easier this way). Insert the screwdriver and begin turning SLOWLY. I cannot stress this point enough – it doesn’t take many turns, so be slow! Once done, swap sides. Most manufacturers recommend a 1.5° downward angle for headlights.
What should the angle of the bi-xenon headlights be?
Insert the screwdriver and begin turning SLOWLY. I cannot stress this point enough – it doesn’t take many turns, so be slow! Once done, swap sides. Most manufacturers recommend a 1.5° downward angle for headlights. Thus at 20 feet, your headlights should be aimed about .5″ lower than your headlights.
What should be considered when adjusting a headlight?
To enable optimal lighting of the road by the headlight, a number of factors should be considered such as the cleanliness of reflector and plexiglas (perspex) cover, adequate fixation, the right lamp as well as the correct adjustment. A headlight with faulty adjustment could blind oncoming traffic or fail to illuminate the road.
Can a screwdriver be used to adjust the headlight?
Adjusting the headlight When the desired value is marked on the wall, the headlight can be adjusted with the screwdriver. A few turns should be sufficient. The process is repeated with the other headlamp. Now the car headlights are adjusted, clean and safe. Nothing stands in the way of successful MOT inspection.