How do you wire auto temp gauge?

How do you wire auto temp gauge?

Connect one wire from the gauge light to a grounded metal part of the vehicle chassis using an existing bolt or self-tapping screw. Connect the other wire to a positive (+) 12 volt wire from the dashboard lighting circuit using a wire tap-splice. Clip the gauge light into the hole in the back of the temperature gauge.

How do you hook up a coolant temperature sensor?

Replacing this sensor is an easy project that can be done in your own garage or on a flat driveway.

1. Step 1 – Open Car Hood.
2. Step 2 – Locate Coolant Temperature Sensor.
3. Step 3 – Remove Lead Wire from Terminal.
4. Step 4 – Loosen Coolant Sensor.
5. Step 5 – Remove and Replace.
6. Step 6 – Torque Sensor in Place.
7. Step 7 – Reconnect Wire.

Where should I place my water temperature sensor?

Coolant hose outlet, DS of block going into the top of the radiator. It has a nice little flat spot that seems to be perfect for a sensor.

How to change the wiring on a Toyota Celica?

SIZED FOR PRINT REMOVE REAR END COVER a. b. ZOOM 2. Remove the nut and terminal insulator. Remove the bolt, 3 nuts, plate terminal and end cover. SIZED FOR PRINT REMOVE BRUSH HOLDER AND VOLTAGE REGULATOR a. b. c. Remove the brush holder cover from the brush holder. Remove the 5 screws, brush holder and voltage regulator.

How much torque does a Toyota Celica have?

SIZED FOR PRINT REMOVE PULLEY a. b. ZOOM Hold SST (A) with a torque wrench, and tighten SST (B) clockwise to the specified torque. SST 09820-63010 Torque: 39 Nm (400 kg.cm, 29 ft.lb) Check that SST (A) is secured to the rotor shaft. SIZED FOR PRINT fPage 3 of 9 c. d. ZOOM Mount SST (C) in a vise.

Where is the fuse box on a Toyota Celica?

Always use a genuine Toyota fuse or equivalent. Do not modify the fuses or fuse boxes. If the replaced fuse blows again, have the vehicle inspected by any authorized Toyota dealer or repairer, or another duly qualified and equipped professional. The fuse panel is located behind the cover on the passenger’s side of the central console.

How to install generator washer on Toyota Celica?

SST O9286-46011 Remove the generator washer from the rotor REMOVE ROTOR FROM DRIVE END FRAME REASSEMBLY ZOOM 1. SIZED FOR PRINT INSTALL ROTOR TO DRIVE END FRAME a. b. Place the drive end frame on the pulley. Install the rotor to the drive end frame. fPage 5 of 9 ZOOM 2. SIZED FOR PRINT INSTALL RECTIFIER END FRAME a.