How do you reset the timing belt light on a Toyota Coaster?
the reset procedure of the timing belt light is all done by pressing the trip meter button and holding it in whilst the ignition is turned to on then select from the trip button then continue pressing until you come to 15 on trip metre, turn off and then restart. The light should then go off.
What does it mean when timing belt light comes on?
It is probable that it is just a mileage-activated warning, so really just a reminder. In that case the belt might have already been changed, but the reminder light not reset at that time. Or it could be some output from a sensor that is indicating a possible problem.
How do you reset the timing belt light on a 2011 Toyota Land Cruiser?
Follow the instructions below to reset the T-Belt Light on your Toyota Land Cruiser J200:
- Turn the ignition key to the “ON” position without starting the engine.
- Press the ODOMETER/TRIP button repeatedly until you see “ODO”
- Next, turn the ignition “OFF”
Why does my timing belt warning light come on?
My warning light came on today at just over 120,000 miles. I had the timing belt changed at 106k so I was a bit concerned. The AA told me that the warning is linked to the odometer, rather than a sensor and that I don’t need to worry.
How do you reset the timing belt on a Land Cruiser?
There should be a little bung in the clear plastic on the front of the instrument cluster and in line with that on the face of the cluster is a pin. Remove the bung and push the pin to reset it. My warning light came on today at just over 120,000 miles. I had the timing belt changed at 106k so I was a bit concerned.
Can a bad timing belt cause engine damage?
However, if the issue is due to the timing belt being broken, it may also result in other internal engine compartment damage. In many cases, the timing belt will break while the engine is running.
What should I do after replacing my timing belt?
After you check this you can remove the belt by loosening the tensioner. Now you can unbolt the tensioner pulley and replace it. By doing a belt tensioner replacement it should eliminate all the sounds you were hearing. This will also ensure that your belt is in its proper placement that way your engine is protected.
https://www.youtube.com/watch?v=fRXaUIO9pFo