How do you reset the fuel gauge on a Chevy Malibu?
How to Reset a Fuel Gauge
- Turn the ignition switch to the “On” position.
- Press the “Odo/Trip” button until the odometer is put into “ODO” mode.
- Turn off the ignition.
- Press and hold the “Odo/Trip” button.
- Release the “Odo/Trip” button.
What causes the gas gauge to malfunction?
The most common problem that causes the fuel gauge to read incorrectly is a bad fuel sending unit. This ensures that the driver is aware of the fuel level at all times, as well as warn when the vehicle is low on fuel, and when to visit a gas station before the tank is completely empty.
Can you reset your gas gauge?
Press and hold the “Trip/Odo” button. Turn the ignition switch on and hold the “Trip/Odo” switch for about two seconds. Then, release the “Trip/Odo” button, press it again (do this three or four times), and finally hold it for about four to five seconds until the leveling information shows on the Odometer.
Why does my gas gauge go past full?
The most common cause of a fuel level gauge of this type to read only past full is if the “S” terminal of the gauge is somewhere shorted to chassis ground or of the sender is internally shorted to ground. While the sender wire is off of the gauge, you may use an ohm meter to measure the resistance of the sender.
How do you diagnose a gas gauge problem?
Disconnect the wire that connects the fuel gauge to the sender unit, then turn the vehicle on. If the fuel gauge reads full, this indicates a problem with the sender unit or the in-tank mechanism. If the gauge continues to read empty, you most likely have a faulty fuel gauge that needs to be replaced.
How do you diagnose a bad fuel gauge?
A faulty fuel gauge sender may cause the gauge to suddenly change positions, or give an inaccurate reading. The gauge may appear to be at three quarters, and then only a few minutes later will change to half full, or vice versa the gauge may appear to be full, only to have the gauge climb higher a short while later.
Why does my gas tank gauge not move?
If the dash gauge now reeds empty, the gas tank unit is defective. If the dash gauge needle fails t move, the dash gauge is defective. If the gas gauge works, but reads lower than it should, check for defective wiring between the gas gauge and the tank sending unit.
What to do if your gas gauge reads lower than it should?
When the gauge reads lower than it should, check at the gauge by disconnecting the wiring from the tank unit. Turn the ignition on and if the needle reads full or above, the gauge unit is probably good and the tank unit or the wiring leading to it are probably the problem. Reconnect the tank unit wire to the gauge before proceeding.
What causes the gas gauge needle to move?
The variations in the amount of fuel in the tank cause the arm to move. This changes the resistance of the tank unit, changing the amount of current at the gauge unit coils, which in turn moves the needle located between the coils.
Where is the gas gauge located on a Chevy truck?
The gas gauge, often located in the instrument cluster, consists of two small coils spaced 90 degrees apart with an armature and a needle placed at the intersection of the two coils. A dampener is also located on the armature to prevent excessive needle movement on rough roads.