How do you replace a CV joint on a Nissan Pulsar?
Use the ball joint separator to remove the other end of the lower control arm from the steering knuckle. Swing the steering knuckle and hub assembly to the side, and pry the CV joint/shaft out of the Pulsar’s transaxle/transmission using a flat head screwdriver. Then, pull the other end of the shaft out of the hub assembly.
How to remove the right hand CV joint on a Nissan Navara?
Hi KenRe Navara CV jointI cann’t turn the knuckle around to remove CVBruceB AU Auto Mechanic: Ken, Australia Car Mechanic replied 11 years ago Hi Bruce. Which knuckle do you mean? You have undone the 6 bolts on the inner CV, Do you have the inner CV dropped down?
How to remove a cv shaft from a Nissan?
IE: no free balls, cage, and gear thing. They will all still be together inside the CV cup as an assembly. -Next, grab the shaft and clamp it in a vise with the dissembled end up (optional). Using snap ring pliers, remove the snap ring and gear thing.
What should I do if my CV axle comes loose?
You can use a small pry bar or sturdy flathead screwdriver to pry the axle from the joint. If the axle doesn’t immediately come loose, try twisting it back and force to break the seal. It’s normal for some transmission fluid to leak out as you remove the axle from the cv joint. You should put down a catch pan.
How to remove CV joints from Nissan truck?
-Chock rear wheels, jack up truck, place on jack stands, and remove front tire (21mm). Then remove cotter pin and back nut off until the nut face extends past the spline. -Remove tie rod end cotter pin, then remove nut (22mm) and tie it up out of the way.
How do you remove the cv shaft from a car?
Remove the CV shaft from the hub bearing and steering knuckle assembly completely by hand. Place a pry bar in between the transmission housing and the CV axle bearing, and pry the CV axle free from the transmission gently. This process works only on the driver’s or left side of the vehicle.
You can use a small pry bar or sturdy flathead screwdriver to pry the axle from the joint. If the axle doesn’t immediately come loose, try twisting it back and force to break the seal. It’s normal for some transmission fluid to leak out as you remove the axle from the cv joint. You should put down a catch pan.
How to install a CV nut on a Nissan?
Clean the wheel bearing area and then angle the spindle out and back and place the stub in the wheel bearing. Line up the splines and push the spindle up to its normal position. Some anti seize on the spline/threads is always good here. Install axle nut and snug it up, install the cotter pin.