How do you replace a crank position sensor?
Compare the old sensor to the new one to ensure a correct fit. The crank sensor might have a separate O-ring. Install the new O-ring on the new sensor. Place the new sensor in its socket. Reinstall the mounting screws and torque to around 15 to 20 ft-lbs. Reinstall the electrical connector.
What happens to the crank sensor on a GMC?
The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.
What happens when the cam and crank sensors fail?
Both sensors usually fail gradually, as the signal to the PCM weakens. Symptoms of a failing cam or crank sensor are generally the same, and include poor acceleration and gas mileage, misfires, rough idle, stalling, and a check engine light. When the camshaft position sensor fails completely,…
What are fault codes related to the crankshaft position sensor?
Fault codes related to the crankshaft position sensor are: P0335 Crankshaft Postion Sensor A Circuit Malfunction P0336 Crankshaft Position Sensor A Circuit Range / Performance P0337 Crankshaft Position Sensor A Circuit Low Input P0338 Cranshaft Position Sensor A Circuit High Input P0339 Crankshaft Position Sensor A Circuit Intermittent
Can you replace a faulty crankshaft position sensor?
By following the guidelines above, you will be able to successfully replace a faulty crankshaft position sensor. However, if you are not comfortable doing the work yourself, a certified technician, like one from YourMechanic, can complete the crankshaft position sensor replacement for you.
The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.
Where is the sensor on the crankshaft pulley?
Locate the sensor on the front of the motor near the crankshaft pulley and use the appropriately sized socket and ratchet handle to remove the sensor’s hold down bolt. Gently but firmly, twist and pull the sensor to remove it from the engine.
Can a bad crankshaft sensor cause the engine to stall?
If the crankshaft position sensor or its wiring have any issues, it can cause the crankshaft signal to be cut off while the engine is running, which can cause the engine to stall. This is usually a symptom of a wiring problem, however a bad crankshaft position sensor can also produce this symptom.