How do you remove the rear axle on a Jeep Cherokee?

How do you remove the rear axle on a Jeep Cherokee?

Instructions

1. Remove the Wheels and Tires.
2. TIP – Using Penetrating Oil on all the nuts and bolts first will really help the process.
3. Remove the shock bottoms with a ¾” socket.
4. Remove the rear driveshaft end from the axle with an 8mm socket wrench and a screwdriver to hold the shaft from spinning.

How do you remove a rear wheel bearing without a puller?

Steps to take if you want to know how to remove bearing from the shaft without a puller

1. Select the right surface.
2. Apply the vehicle’s parking brake.
3. Use a car jack to raise your vehicle.
4. Place jack stands under your vehicle.
5. Remove the coverings and trays that are in the way.
6. Remove the tires.

What is the difference between an axle bearing and a wheel bearing?

The differences between front wheel bearings and axle bearings are significant. Wheel bearings are installed in pairs consisting of both inner and outer bearings, whereas axle bearings are installed as a single bearing and only support the outer end of the axle shaft.

What are the symptoms of a bad rear axle bearing?

What are the symptoms of bad wheel bearings

• A humming, rumbling or growling noise that increases with acceleration or as the vehicle turns.
• A loud constant whining or grinding noise when the vehicle is in motion.
• Clunking noises when driving over uneven road surfaces.

  How do you remove the rear axle from a jeep?

  If you forgot your penetrating oil at home use anything handy like transmission fluid or brake fluid. Remove the shock bottoms with a ¾” socket. Remove the rear driveshaft end from the axle with an 8mm socket wrench and a screwdriver to hold the shaft from spinning.

  How do you replace rear wheel bearings on a jeep?

  Use these instructions to replace the rear wheel bearings on your Jeep Cherokee. (Related Article: How to Replace Front Wheel Bearings – CherokeeForum.com) Loosen each lug nut on your wheels and raise the chassis of the Jeep. While the Jeep is in the air, locate the jack points and secure the chassis using jack stands.

  How much does it cost to remove rear axle bearing?

  If you cannot do that, you’ll have to have a shop do it (they will usually remove the old bearing for free and replace the seal). When I replaced both axle seals I took both rear axles to the shop (just as they came out of the housing) and they removed and replaced the collars, bearings, seals, and plates for $30/axle.

  Can a bad wheel bearing cause a Jeep Grand Cherokee to lock up?

  It is not recommended to drive your Jeep Grand Cherokee on a bad wheel bearing. They are dangerous. As they go bad they create heat. This heat can eventually cause the tire to lock up while going down the road. Replacing a wheel bearing is not that expensive, even if you take it in to a shop. Good luck diagnosing your Grand Cherokee.