How do you remove the front bumper on a Toyota RAV4?
Apply protective tape under the front fender and headlight. Using a screwdriver, detach the 4 claws. Hint: Tape the screwdriver tip before use. W/ fog light: disconnect the 2 fog light connectors. Using a clip remover, remove the hood cushion center. Using a clip remover, remove the 4 clips and remove the front bumper cover.
How to remove steering column from Toyota RAV4?
Detach the power steering motor wire harness and torque sensor wire harness clamps from the power steering ecu side. Disconnect the 2 steering column connectors from the power steering ecu. Turn back the floor carpet, remove the 2 clips and remove the column hole cover silencer sheet.
Can a dent be made in a RAV4 bumper?
Usually bumpers are flexible to absorb impact so it should go back to its original shape. If it looks ok afer pushing out the dent then maybe you do not need to buy that bumper. When I bought my RAV4 the front bumper was dented in but I took it off and pushed out the dent and now it looks ok with some minor scuff marks.
Where is the ignition switch on a Toyota RAV4?
Insert the tip of a screwdriver into the hole in the steering column bracket upper, as shown in the illustration, and pull the ignition switch lock cylinder out until its claw comes into contact with the stopper of the steering column bracket upper.
How do you remove a headlight from a Toyota RAV4?
Turn the bulb in the direction indicated by the arrow and pull to remove it. Turn the bulb in the direction indicated by the arrow and pull to remove it. Turn the bulb in the direction indicated by the arrow and pull to remove it. Turn the bulb/socket unit in the direction indicated by the arrow and pull to remove it.
Where is the light control switch on a Toyota RAV4?
Description When the light control switch, located on the headlight dimmer switch, is turned to the tail position, the taillight relay (marking: t-lp) turns on to illuminate the front side marker Components Removal Hint: Use the same procedures for the rh and lh sides.
How do you adjust the aiming on a RAV4?
Adjust the aim vertically by turning the vertical aiming screw and the horizontal aiming screw at a 5:4 ratio (5 turns of the vertical aiming screw for 4 turns of the horizontal aiming screw). If the screw is tightened too much, loosen it and then retighten it so that the final turn of the screw is in the clockwise direction.