How do you remove front door panel on Hyundai Elantra?
Using a flat screwdriver to remove the front door side mirror inner cover. Remove two Phillips screws that hold the door panel in place. One of the screws is near the door handle. The second screw that needs to be removed is in the center of the door panel.
How many trim levels does the Hyundai Elantra have?
There are six trim levels for the 2018 Hyundai Elantra, with three engines and three transmissions shared among them. The base SE has a pretty limited equipment list, but moving up to the SEL, the Value Edition and finally the Limited nets quite a few improvements.
Is the Hyundai Elantra SE a good car?
The good news is that on smooth pavement, the Elantra is extremely quiet and composed. Bearing in mind that the Elantra SE is a budget car, the ride is very good, overall (at 32/33 psi). The stereo/radio sounds OK. It is quite good, again, for a budget car.
Using a flat screwdriver to remove the front door side mirror inner cover. Remove two Phillips screws that hold the door panel in place. One of the screws is near the door handle. The second screw that needs to be removed is in the center of the door panel.
How are door panels held on Hyundai Accent?
Hyundai door panels are held on primarily with trim fasteners which resemble large plastic stove bolts. They have a large, round, flat head and serrated shaft that hold through use of friction from the serrations. A common screwdriver and a Phillips screwdriver will be needed. Remove the Phillips screws in the arm rest.
What do you need to remove a car door panel?
This padded cardboard item is held on by a series of screws and plastic clips that must be removed to service such items as a window switch , door lock and window motor and regulator. All door panels basically perform the same task though the process a door panel removal will vary slightly for each vehicle.
Where are the trim pieces on a door panel?
Most door panels will have small trim pieces located at the top of the panel at either the right or left side. Use a small screw driver or trim removal tool and detach (pop off) any trim pieces above the door panel.
Where is the seal on a Hyundai Accent door panel?
The door panel is hooked onto the top ledge where the window felt or seal is located. The curved edge at the top hooks to the horizontal ledge so while the bottom of the panel is tipped outward lift up to unhook and move the panel away from the door a few inches.
How do you remove a door panel from a car?
Insert a screwdriver into the edge of the armrest cover and pry it off. The armrest cover may be concealing a fastening screw. Take a flathead screwdriver and wedge it into the crack at the edge of the panel. Apply gentle pressure to pop it out and remove it.
How do you remove a front door panel?
Now that you know how door panels are assembled, you just need to reverse the process. If you have manual windows, start by removing the window crank. Some window cranks are screwed in place. The screw is either in plain sight or hidden under a vanity cap in the center of the large circular part of the crank.
How do you remove the passenger side mirror?
These instructions are shown on the front driver’s door panel, but the passenger and rear panels can be removed following the same method. Using a flat screwdriver to remove the front door side mirror inner cover. Remove two Phillips screws that hold the door panel in place. One of the screws is near the door handle.
What to look for when removing door trim?
Check along the latch side of the door trim panel. And don’t forget to check under reflectors. Here’s one under the door pull area. Don’t forget to check under reflectors and along the latch side of the door panel. If your door panel has carpet, feel for screws hidden along the bottom edge of the carpet.