How do you remove cooler lines from transmission?
Remove the two transmission cooler lines from the side of the transmission with a flare nut wrench. To use the wrench, slide the open end of the wrench over the cooler line, then slide the wrench down the line until it reaches the nut used to secure the line to the transmission.
What happens when transmission lines leak at Radiator?
The fluid transmission can be low if the leak within the hydraulic transmission lines goes to the transmission cooler. Any transmission that has a lower amount of fluid than it needs to function correctly will potentially lead to a sharp shift in any equipment.
Why is my transmission cooler not connecting to the radiator?
Problem is that there is not enough room between the raised ridge of the tube where the secondary plastic locks in place and the actual quick release fitting against the radiator. OR, the round piece that pushes in is too thick to fit between the pipe and fitting.
Why do my tools not fit in my radiator?
Problem is that there is not enough room between the raised ridge of the tube where the secondary plastic locks in place and the actual quick release fitting against the radiator. OR, the round piece that pushes in is too thick to fit between the pipe and fitting. So, none of my tools will fit.
How do you remove cooler line from transmission?
Unscrew the fittings. Remove cooler line from transmission fitting. Pull the line out of the transmission fitting, taking care not to bend the line. The line is usually made of steel, ranging in width from 5/16-inch to 3/8-inch with a flare nut on the end. It can be up to 5 feet in length, but it depends on the type of car.
What are the fittings for a transmission cooler?
These fittings are a push fit type that allow for a standard hose clamp to keep the transmission line in place. When it comes to installing an aftermarket trans cooler, barb fittings can be used on the radiator transmission fluid outlet for rubber hose to run to the cooler.
How to remove cooler lines without a quick disconnect tool?
Disconnecting a transmission cooler line without a quick disconnect tool is a fairly simple task provided you have the proper tools. Disconnecting a cooler line while it is attached usually destroys the line itself, because a removal of the cooler line fitting is required. Step 1 Identify cooler line location.
Where can I install an aftermarket Trans cooler?
When it comes to installing an aftermarket trans cooler, barb fittings can be used on the radiator transmission fluid outlet for rubber hose to run to the cooler. These fittings are very cost effective and are typically only a few dollars at most and comes in packs with multiple fittings.