How do you remove an electrical cluster from a Volvo?
They can be torn off when removing or reinstalling. 740 Instrument Cluster Removal. It’s very simple. Place the turn signal and wiper stalks in the down position. Take a super slim screwdriver and remove the small plastic cap surrounding the small clock set knob on the left and the cap surrounding the dash light dimmer on the right.
How do you remove the speedometer from a Ranger?
1) Disconnect the negative battery cable. 2) Open the ash tray and remove the two retaining screws. Remove the ash tray assembly from the dash. 3) If necessary, remove the left and right A/C register vents from the dash.
How do you remove an electrical instrument cluster?
Once that is gone, you can remove the instrument cluster by unscrew ing the 4 screws on the 4 corners of the cluster. Slowly pull the cluster forward. With the help of a screwdriver, push the black wire, running on top of the cluster, away from the two wire holders. Slide the left side of the cluster out first.
How do you disengage the cable on a speedometer?
To disengage the cable, you need to push up firmly on the bottom (6 o’clock position) while pulling the cable away from the cluster. 1) Apply approximately 3/16-inch diameter ball of silicone dielectric grease in the drive hole of the speedometer head. 2) Position the instrument cluster near its opening and attach the electrical plugs to it.
How do you fix a Toyota Speedo cluster?
While you are cleaning the contacts you should also clean the contacts where the 4 screws go that hold the speedo into the cluster, as well as the contacts for where the 3 wiring harnesses plug in. Now put everything back together and enjoy your working speedo.
How do you fix a speedometer on a Toyota?
1. remove 2 screws from the trim ring around the gauge cluster. 2. remove 4 screws that actually hold in the gauge cluster. 3. pull cluster put slightly and then remove the 3 wiring harnesses from the back. 4. remove the cluster the rest of the way from the dash.
How do you remove an instrument cluster on a Volvo?
740 Instrument Cluster Removal. It’s very simple. Place the turn signal and wiper stalks in the down position. Take a super slim screwdriver and remove the small plastic cap surrounding the small clock set knob on the left and the cap surrounding the dash light dimmer on the right. Under each of these is a phillips screw.
Once that is gone, you can remove the instrument cluster by unscrew ing the 4 screws on the 4 corners of the cluster. Slowly pull the cluster forward. With the help of a screwdriver, push the black wire, running on top of the cluster, away from the two wire holders. Slide the left side of the cluster out first.