How do you put a window regulator in?
NOT TOO TIGHT only snug. With the window all the way up, cut the zip tie that’s holding the new gear in the new regulator, being carefull not to let it drop out. Push the three studs through the holes in the metal sheath and they should snap and hold the gear in place. If everything looks good, lift the window frame back into place.
How to install and remove window regulator 741-644?
STEP 1d: Disconnect electrical connections to switch. STEP 1e: Gently pry around door lock bezel and unsnap it from door panel. Unclip from door lock rod and remove. STEP 1f: Using a 7mm socket, remove the 3 highlighted screws. STEP 1g: Lift trim panel up and remove from door. INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR 741-644
How does a BMW front window regulator work?
The window regulator assembly is made up of the window motor, drive cable and track slides. This design uses two slides and two guides to hold the window in the proper position. The motor and regulator are built as an assembly and typically they are replaced as an assembly. This design uses a cable that wraps around a gear attached to the motor.
What happens if you fail to install window regulator?
Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffi c Safety Administration).
Where is the regulator on a power window?
Locate and remove the window motor mounting bolts. The power window motor is much smaller than the regulator, but should be located close by. In most applications, the bolts securing the motor to the door are the same size as the regulator mounting bolts. Remove them and set them someplace safe as well.
How do you remove a window switch regulator?
Removal Instructions STEP 1: Gain access to the window regulator assembly by removing the interior trim panel. STEP 2: With interior panel removed, peel back the plastic water barrier enough to be able to remove the regulator. STEP 3: Reconnect the window switch electrical connector.
STEP 1d: Disconnect electrical connections to switch. STEP 1e: Gently pry around door lock bezel and unsnap it from door panel. Unclip from door lock rod and remove. STEP 1f: Using a 7mm socket, remove the 3 highlighted screws. STEP 1g: Lift trim panel up and remove from door. INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR 741-644
Failure to do so may result in property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffi c Safety Administration).