How do you light a gas fireplace with electronic ignition?
Re-lighting pilot lights is straightforward on today’s modern gas fireplaces. If you have an electronic ignition unit, using your remote control simply press the ‘on’ button and the pilot will re-ignite within a few seconds, followed by the fireplace a few seconds after that.
How do you turn on gas fireplace with wall switch and key?
You will control the gas flow with a fireplace key (sometimes called a hex key) as you light the fireplace.
- Place a long lighter next to the burner and pull the fuel trigger.
- Turn the key in the slot to open the gas valve.
- Replace the key cover.
- Use the key to control the height of the flames.
How do you use a valve key on a fireplace?
For fireplaces with a control panel, it’s as easy as turning the control knob to off. You should close or turn off the emergency gas valve. For those with a key valve, just insert the fireplace key into the slot and turn it until the valve closes. This cuts off the gas supply, and the pilot will go out.
How do you light a fireplace with keys?
Igniting with a Fireplace Key
- Look over the user manual included with your fireplace.
- Remove your fireplace’s outer cover.
- Put a fireplace key into the device’s gas valve knob.
- Hold a long lighter up to the burner and ignite it.
- Turn the gas key.
- Replace the fireplace’s outer cover immediately.
How do you light a gas fireplace key?
How do you turn on a pilot light?
Turn the gas regulator valve to the “pilot” position. If the water heater has a manual “ignite” button, press that to light the pilot. If it doesn’t have the button, or the button fails, press the regulator valve and hold a grill lighter or long match to the pilot light valve until the pilot ignites.
How do you turn on a gas fireplace without a key?
When learning how to turn on a gas fireplace without a key, see if the unit has a control panel with an igniter switch. If you’re using a fireplace key and your fireplace has a front cover, remove it completely and set it aside to access the burner. If the control panel’s pilot knob is not already in “Off” position, turn it off.
What’s the best way to light a gas fireplace?
Turn the knob from the “Off” to the “Pilot” position. Push in the pilot knob, which manually sends gas into the system. Push the igniter button once every second until it lights. Depending on how long it’s been since the gas fireplace was last used, ignition may take multiple attempts.
How often do you push the igniter button on a gas fireplace?
Push the igniter button once every second until it lights. Depending on how long it’s been since the gas fireplace was last used, ignition may take multiple attempts. After the pilot lights, keep the pilot button held down about 15 to 30 seconds to warm up the thermocouple and ensure that the flame stays lit.
Where is the hex key on a gas fireplace?
Some types of fireplaces have a round, decorative slot for controlling the gas valve. It’s usually located near the fireplace, usually to the immediate left, right or on the floor. You will control the gas flow with a fireplace key (sometimes called a hex key) as you light the fireplace.