How do you install a trunk lock cylinder?
Part 1 of 2: Removing the old trunk lock cylinder
- Materials Needed.
- Step 1: Pop the trunk and remove the trunk liner.
- Step 2: Remove any actuating rods.
- Step 3: Unbolt or unclip the lock cylinder.
- Step 4: Remove the trunk lock cylinder.
- Step 1: Install the new lock cylinder.
- Step 2: Reconnect the actuator rod(s).
How to install a new trunk lock cylinder?
1 Install the new lock cylinder. Feed the new lock cylinder into the hole in the trunk door, rotating as necessary to get it to seat properly. 2 Reconnect the actuator rod (s) Reinstall the actuator rod or rods into the clip on the lock cylinder. 3 Test the new mechanism. 4 Reinstall the trunk liner. …
How do you remove a lock cylinder from a car?
The lock cylinder usually comes out by gently pushing it out from the inside. You may need to rotate the cylinder as you are removing it to clear the mounting hole. Step 1: Install the new lock cylinder. Feed the new lock cylinder into the hole in the trunk door, rotating as necessary to get it to seat properly.
How do you change an interchangeable lock cylinder?
Changing an Interchangeable Lock Cylinder Remove the flat screw under the latch. Prop open the door as you change the lock. Turn the key a quarter of the way. Insert the key into the keyhole and turn it slightly so that it’s in the open position. Pull on the key while pushing on the other side of the lock.
How do you change the lock cylinder on a storefront door?
Replacing a Storefront Door Lock Cylinder Unscrew and remove the faceplate over the latch. Loosen the set screw near the lock itself. Insert a key into the lock and turn it clockwise to unscrew it. Thread a new lock cylinder into the hole. Insert a mismatching key into the lock and turn it clockwise. Re-tighten the set screw.
1 Install the new lock cylinder. Feed the new lock cylinder into the hole in the trunk door, rotating as necessary to get it to seat properly. 2 Reconnect the actuator rod (s) Reinstall the actuator rod or rods into the clip on the lock cylinder. 3 Test the new mechanism. 4 Reinstall the trunk liner.
How does a trunk lock work in a car?
Today’s trunk locking mechanisms are comprised of a keyed lock cylinder and a trunk lock actuator in cars that offer a power trunk release once activated. The trunk lock actuator then releases the trunk latch so the trunk can be opened.
The lock cylinder usually comes out by gently pushing it out from the inside. You may need to rotate the cylinder as you are removing it to clear the mounting hole. Step 1: Install the new lock cylinder. Feed the new lock cylinder into the hole in the trunk door, rotating as necessary to get it to seat properly.
What should I do if my trunk lock actuator is broken?
If you try to unlock the trunk with the fob or switch in your car and it doesn’t work, but the manual lock works fine, this is a clear cut signal that your trunk lock actuator is broken. There is no repair that can be done at this point and you will have to contact a mechanic so they can replace the trunk lock actuator.