How do you check the transmission fluid on a 2004 Suzuki Forenza?
There is no dipstick to check the automatic transmission fluid in the 2004 Suzuki Forenza. It is checked like a manual transmission. You will have to remove the fill plug underneath the car and then add some new transmission fluid until it drizzels out of the hole.
How do you check the transmission fluid on a Suzuki Forenza?
Checking the Manual Transmission Fluid Level
- Park the Forenza on a flat surface and engage the parking brake.
- Crawl beneath the vehicle and locate the transmission check-and-fill plug on the driver’s side of the transmission, just behind the drive axle.
How do you check the transmission fluid in a Suzuki?
You must check the fluid level with the automatic transmission fluid at normal operating temperature. To check the fluid level: 1) To warm up the transmission fluid, drive the vehicle or idle the engine until the temperature gauge indicates normal operating temperature. 2) Then drive for ten more minutes.
How do you check the transmission fluid on a 2005 Suzuki Verona?
With the engine running in PARK, remove this plug. If trans fuild doesn’t run out of the hole, the level is low. Pour it in the hole on top (where the red cap is) until the fluid runs out – all while the car is running. Once it is roughly dribbling out, the trans is considered full.
What kind of transmission does a Suzuki Forenza have?
The 2006 model year Forenza came in two trim levels, Base and Premium, both of which came standard with a 126-horsepower, 2.0-liter engine and a five-speed manual transmission; both trim levels also had the option of adding in a four-speed automatic transmission in the manual’s place.
What kind of transmission fluid does a Suzuki use?
Use an automatic transmission fluid SUZUKI ATF 3317 or Mobil ATF 3309. Driving with too much or too little fluid can damage the transmission. You must check the fluid level with the automatic transmission fluid at normal operating temperature.
How do you check the fluid level in a Suzuki?
3) Park your vehicle on level ground. 4) Apply the parking brake and then start the engine in “P” (Park). Let it idle for two minutes and keep it running during the fluid level check. 5) With your foot on the brake pedal, move the gearshift lever through each gear, pausing for about three seconds in each range.
Can a Suzuki dealer change the transmission oil?
After checking or adding oil, be sure to insert the dipstick securely. Since special procedures, materials and tools are required to change the automatic transmission oil, it is recommended that you trust this job to your authorized SUZUKI dealer.