How do you change the mode on Balboa spa?
Depending on system configuration, mode changing may not be available and will be locked in Standard Mode. Mode is changed by pressing “Temp,” then “Light”. Standard Mode maintains set temperature. will be displayed momentarily when you switch into Standard Mode.
How do you program a Balboa spa?
To program, press “Temp,” then “Jets 1.” Press “Temp” to adjust. Press “Jets 1” to exit programming. For non-circ systems, low-speed pump 1 and the ozone generator (if installed) run during filtration. For 24 hour circulation systems, the circ pump and the ozone generator (if installed) run 24 hours.
How do I reset my Balboa hot tub control panel?
Remove the spa cover and allow water to cool. At 107¡F (approximately 41.7¡C), the spa should automatically reset. If spa does not reset, shut off the power to the spa. Standby Mode has been activated by pressing a button combination on the user panel.
How do I know what Balboa hot tub I have?
The number referenced here on the panel is the product serial number along with the product part number. On this topside panel the serial number is 52649-01200508020042. The first five numbers along with the dash and the two proceeding numbers will be the product part number.
How do I get my Balboa hot tub out of sleep mode?
On screen it will just state rest mode or whilst running filteration it will state “run” “pump” “for” “temp”. TO EXIT REST MODE:- Press Temp, then press light repeatedly until ‘MODE’ appears in the LCD. Toggle between READY and REST by pressing temp. Press light or wait for 10 seconds to go back to the Main Screen.
How do you unlock Balboa spa control?
Spas using Balboa control systems To unlock the panel, while holding down the “Temperature” button (or the “Up” button if you do not have the “Temperature” button), gently press and release the “Light” button twice.
How do you get a hot tub out of Balboa SL mode?
TO EXIT REST MODE:- Press Temp, then press light repeatedly until ‘MODE’ appears in the LCD. Toggle between READY and REST by pressing temp. Press light or wait for 10 seconds to go back to the Main Screen.
Why is my hot tub not getting hot?
If your spa heater won’t heat, remove and clean the filter(s) to rule out a pressure or flow rate problem in your hot tub heater. Low water level, a clogged pump impeller, closed valves, clogged pipes, or blocked spa drain covers can also cause flow issues.