How do you change an oil separator on a Porsche?
On the pre 2006 cars here are basically two ways to change the oil separator. The easiest is to drop the engine out of the car. This allows you full access to the lines and connections of the separator. The other method is to remove the separator with the engine in the car.
How to replace air separator in Porsche 911 Carreras?
(1998-2005 Carreras) Remove the two 8mm screws holding the hose connection to the front of the left intake manifold. These screws also hold the retaining plate for a vacuum solenoid at the left of the hose connection. Once free, maneuver the hose, plate and solenoid up and out of the way.
How to replace a Porsche 911 Carrera starter?
Begin by removing the air hose connection to the oil separator. Squeeze the black plastic connector to disconnect the hose from the plenum. Once free, set the hose connection aside. Now loosen the hose clamps securing the plenum to each manifold.
What to do if your air oil separator fails?
It’s also important to be able to detect the signs of trouble or failure of the air-oil separator in your Porsche so you can bring it to a professional Porsche specialist immediately for repair. Here is some helpful information about your car’s air-oil separator:
On the pre 2006 cars here are basically two ways to change the oil separator. The easiest is to drop the engine out of the car. This allows you full access to the lines and connections of the separator. The other method is to remove the separator with the engine in the car.
(1998-2005 Carreras) Remove the two 8mm screws holding the hose connection to the front of the left intake manifold. These screws also hold the retaining plate for a vacuum solenoid at the left of the hose connection. Once free, maneuver the hose, plate and solenoid up and out of the way.
It’s also important to be able to detect the signs of trouble or failure of the air-oil separator in your Porsche so you can bring it to a professional Porsche specialist immediately for repair. Here is some helpful information about your car’s air-oil separator:
Begin by removing the air hose connection to the oil separator. Squeeze the black plastic connector to disconnect the hose from the plenum. Once free, set the hose connection aside. Now loosen the hose clamps securing the plenum to each manifold.
How to do an oil change on a Porsche Carrera?
Verify that there’s no volume of oil seeping out of the engine. Take the car out for a drive and bring it up to operating temperature. Shut the car off and then recheck the oil level (careful, the car will be hot). At this point, I like to top the oil off at the top point on the dipstick.
What happens when the air separator fails on a Porsche 911?
When this unit fails, the result is oil sucked out of the engine and into the intake. While the air-oil separator will not cause immediate mechanical damage to your engine, it may make it smoke tremendously and/or run roughly (see Pelican Technical Article: Porsche 911 Air Oil Separator).
What to do if Porsche C4 battery is flat?
I have 2003 C4S and use the ctek trickle charger through the cigarette lighter. Solves the problem of the flat battery after a few days. Not so sure on the other problem. The ctek will also condition the battery. They are about £80 on amazon. Hope you get it sorted
Can a Porsche Boxster air oil separator be replaced?
There have been many updates to the unit over the years. The later-style units are a direct bolt-on replacement, but the hose that connects the air-oil separator to the throttle body has been updated as well (the old one is a little too short).
How to change the oil separator on a Porsche 911?
To release the tension on the belt attach a 24mm socket to a breaker bar, place it on the idler arm and turn it clockwise (see Pelican Technical Article: Replacing Belts on the Porsche 911 Carrera ). After you have removed the accessory belt you will need to remove the power steering reservoir on the right side of the engine.
How do you replace an air oil separator?
If you are replacing your air-oil separator with a new one, be sure to install the updated connecting hose as well. With the engine compartment lid open, it’s fairly easy to gain access to the air-oil separator connections.