How do you change a radiator fan on a Mini Cooper?
Removal of the Aero kit bumper may have some differences.
- Step 1 – Lift the front onto jack stands.
- Step 2 – Remove the front bumper.
- Step 3 – Remove the crash bar.
- Step 4 – Remove the radiator push pins.
- Step 5 – Disconnect top radiator hose from the radiator.
- Step 6 – Remove the cooling fan.
How do you drain a Mini Cooper radiator?
You need to remove the lower radiator hose in order to drain the system. Place a drain pan or other suitable container under the hose then pull off the hose and let it drain. Make sure you also remove the cap on the coolant expansion tank and also open the vent valve on the upper radiator hose..
How to add coolant to a Mini Cooper?
How to Add Coolant: Mini Cooper (2008-2015) 1. Getting Started – Prepare for the repair 2. Open the Hood – How to pop the hood and prop it open 3. Find Reservoir – Locate the coolant reservoir and clean it 4. Check Level – Determine the coolant level 5.
How do you replace a heater fan on a Mini Cooper?
You will have to replace the heater fan motor. To access the motor to replace it, you will first need to remove the MINI Cooper’s dashboard, which can be quite challenging. Lower the steering wheel as far low as it will go.
Where is the condenser located on a Mini Cooper?
In front of the radiator is the A/C condenser. This is secured to the front of the radiator by two 10mm bolts on both the left and right sides (See Figure 2 and Figure 3 ). Loosen but do not remove the bolts. Now look at the front of the intercooler, you will see that the top radiator hose is held to the front with an 8mm bolt.
How to remove and replace a radiator support?
A 1996 Honda Accord was mainly used to demonstrate how to perform this task. Most radiator supports are welded in and have to be cut out and welded back in. If you are interested in learning more on how to do this type of repair and learn true body work and paint, follow this link: If you found this video valuable, give it a like.
Is it hard to replace a radiator hood?
Replacing fenders and hoods are really not that hard as long as you have something that is straight and lined up to bolt them to. The hardest part about replacing a radiator support is cutting the welds. First you have to find and identify all the spot welds you will need to cut out. Then there is the physical work itself.
Do you need a welder to replace a radiator?
Most all car radiator supports are welded in and this often deters your Do-It-Yourselfers from tackling this type of job. Now granted, not everyone has a welder and that can be a big factor of not wanting to try it but most tool rental places rent MIG Welders and that is what you would need to do this job.