How do I reset my response alarm?
Answer: Press and hold the [WiFi] button inside the Control Panel for 7 seconds. You will hear one short beep after 3 seconds and then a long beep after another 4 seconds. The reset has been completed and all the settings have been restored to default conditions.
How do I change my response alarm code?
To change the code, press the corresponding key on the panel to switch it on or off e.g. to have 1 in the ON position, press 1 on the panel (once or twice) until zone 1 is illuminated. Repeat this for the remaining numbers.
Why does my house alarm says tamper?
A tamper means that someone has attempted to open up or disable a programmed sensor. This will cause a trouble condition on the system. By opening up the back cover, a person could potentially remove the backup battery and attempt to power down the system. …
What should I do if my alarm system does not work?
Then, arm the system and open a device on your system (eg. window). Let the system go into alarm (actually making the siren sound). At this point, the system will send a signal to the central station and clear your communication failure. If this does not work, you’ll need a service call so that a trained technician can assess and fix the problem.
How can I Clear Com fail on my alarm system?
To clear “Com Fail” message, call our office and have us put your system on “test.” Then, arm the system and open a device on your system (eg. window). Let the system go into alarm (actually making the siren sound). At this point, the system will send a signal to the central station and clear your communication failure.
Why is it important to reset your alarm system after power outage?
A power outage can disrupt the monitoring of your home security system, whether caused by utility repair or a major storm. Whatever the reason, it’s important to reset your system as soon as you can in order to stay protected.
Why is my home security system not working?
If this does not work, you’ll need a service call so that a trained technician can assess and fix the problem. Some wiring from the control panel to the devices in the house is “supervised” for integrity. If a wire gets cut, chewed through by an animal or just breaks, this could cause a trouble condition on the system.
What’s the best way to reset an alarm system?
Leave power off for a minimum of five minutes. Reconnect the battery leads. With the help of a friend, power up the system. While one person activates the power, the second should be at the alarm system control panel. At the alarm system control panel, press the * (star) and # (pound) keys at the same time.
What causes an alarm system to go out?
Replace the battery in the control panel. Control panel outage, power outage to the house, loss of power to plug, transformer for the system is dead. Check the plug that the system transformer (a little 3″x3″ cube) is plugged into.
A power outage can disrupt the monitoring of your home security system, whether caused by utility repair or a major storm. Whatever the reason, it’s important to reset your system as soon as you can in order to stay protected.
When do I need help with my alarm?
If you need help with a door or window switch that doesn’t show up on the keypad or trip the alarm when open, see “Alarm Switch Troubleshooting – Finding and Fixing Lightning Damaged Alarm Contacts”. Is your alarm system operating erratically? You may need a new alarm system battery.