How do I reset my ML transmission?
Procedure Reset Transmission Adaptive Learning DIY
- Turn the key to position 2. You should see all the dash lights come on.
- Press the gas pedal all the way.
- Wait.
- Turn key to OFF, position 0.
- Release the gas pedal.
- Wait 2 minutes.
- Start the car and drive.
Why does my ml270 gearbox keep locking up?
Check the plug on the gear as it can send oil up to the ecu. If the gearbox keeps locking up it means its not happy and eventually it will be permanently locked and only a computer can unlock. A friend of mine has a 53 reg ML270 and I told him to get it serviced before there are problems.
Are there any problems with the Mercedes ML gearbox?
Gassing Station» Mercedes PistonHeads» Gassing Station» Other Marques» Mercedes Mercedes ML gearbox problems My ProfileMy PreferencesMy Mates SearchMy Stuff What’s New3122472 Mercedes ML gearbox problems Reply Reply Author Discussion MarsellusWallace Original Poster 1,180 posts 167 months [report] [news]
Why is my Mercedes C270 CDI gearbox black?
A simple and cheap change of the multi-connector did the trick but, as my local garage had to lose oil from the box when doing the job, they noticed it was very black. This on a car which had had the ATF changed at 40,000 miles. So it does need doing and regularly.
Why is my Mercedes Benz transmission not working?
Invariably if the code displays an electronic failure the problem could lie with faulty electronics such as speed sensors, solenoids and selector sensors or with the transmission control module itself. These modules are usually damaged by voltage overload, water, vibrations and thermal stress.
Check the plug on the gear as it can send oil up to the ecu. If the gearbox keeps locking up it means its not happy and eventually it will be permanently locked and only a computer can unlock. A friend of mine has a 53 reg ML270 and I told him to get it serviced before there are problems.
What are the most common Mercedes Benz transmission problems?
Top 5 Mercedes-Benz Transmission Problems. Won’t come out of Park gear due to a defective brake light switch. ( DIY How to replace the Brake Light Switch) Continue to read if you would like to learn how to troubleshoot your Mercedes-Benz transmission yourself and where you should start. 1. Check Fluid Level
What to do if your Mercedes gearbox is not working?
Look to the back of the engine, left side you will see a red cap, this pulls off and a specially bought (from Merc) dipstick goes in. Go back to the indie/dealer who changed the oil and get them to dip it, because it could be short on oil (a small leak occurs on the electric connector on these boxes).
What to do when your Mercedes goes into limp mode?
You may also get a check engine light if your transmission goes into limp mode. When a Mercedes-Benz goes into limp mode, it only operates in second gear and reverse only. When you put it in gear, you may also feel a bang as transmission engages. The first thing you should try is to check the transmission fluid level.