How do I reset my Arctic Cat belt light?
650 V2 BELT RESET SEQUENCE
- Turn key off. Disconnect belt failure switch. (2 wire orange & pink/blue) located on top of clutch cover.
- Turn key off.
- Reconnect the (2-wire orange & pink/blue) and the (4-wire).
- Turn key on belt light should no longer be flashing.
Is there a way to reset a Kawasaki Prairie Belt switch?
Many Prairie owners opt to deal with the problem by riding with the light on, since there is no visible way of resetting the light. Doing so is dangerous, however, as the light will not be able to warn you of potential belt problems. Luckily, resetting the light is a quick task that can put an end to your frustration.
What does the belt light on a Kawasaki Prairie mean?
An illuminated belt light on your Kawasaki Prairie’s instrument panel is usually an indication that the ATV’s belt is ready for replacement or adjustment. But, once the belt is taken care off, the light has a habit of sticking around.
Do you need to reset the belt light on an ATV?
The belt warning system on your ATV must be PROPERLY reset and should not be disabled or tampered with. This manual will show you how to properly reset it. Don’t get stranded out in the middle of nowhere without the information you need to reset your belt light and get back on the trail.
Where is the ignition switch on a Kawasaki Prairie?
Unplug the gray and black wiring connectors, located above the CVT belt cover. Plug the male gray connector into the female black connector and the male black connector into the female gray connector. Turn your Prairie’s ignition switch to the On position.
Many Prairie owners opt to deal with the problem by riding with the light on, since there is no visible way of resetting the light. Doing so is dangerous, however, as the light will not be able to warn you of potential belt problems. Luckily, resetting the light is a quick task that can put an end to your frustration.
An illuminated belt light on your Kawasaki Prairie’s instrument panel is usually an indication that the ATV’s belt is ready for replacement or adjustment. But, once the belt is taken care off, the light has a habit of sticking around.
The belt warning system on your ATV must be PROPERLY reset and should not be disabled or tampered with. This manual will show you how to properly reset it. Don’t get stranded out in the middle of nowhere without the information you need to reset your belt light and get back on the trail.
Unplug the gray and black wiring connectors, located above the CVT belt cover. Plug the male gray connector into the female black connector and the male black connector into the female gray connector. Turn your Prairie’s ignition switch to the On position.