How do I find a short circuit on my motorcycle?
put the ground probe (negative black probe usually) on the disconnected battery wire. check for continuity between all the fuses on both sides. If the continuity(good connection) is good, wiggle some wiring while you test. then if you see a flux on the meter or a high ohms or infinity, you have found the short.
What to do if you have an electrical problem on your motorcycle?
When you have an electrical problem start by testing whether the faulty component is properly grounded. This can be done by connecting a multi-meter set to OHMS between your negative battery terminal and any metal part on your bike.
Can a faulty wire grounds cause a motorcycle to die?
Faulty wire grounds are a very common problem, but can sometimes be difficult to track down. Symptoms of a bad ground can range from a completely dead bike to electrical components working intermittently. Checking all of the grounds on your motorcycle can be done quickly if you know where they all are.
What are the symptoms of a motorcycle problem?
They are: Engine halting at the middle of the road or not starting at all. Not getting a good throttle response. Braking Problems. Electrical problems. Strong vibrations or jerking at top speed. High fuel consumption. 1. Motorcycle Engine Halting At The Middle of The Road or Not Starting At All :
Do you need a multimeter to troubleshoot a motorcycle?
The purpose of this guide is to help riders to begin the process of troubleshooting motorcycle electrical problems. You will need a multimeter and the shop manual for your specific motorcycle to troubleshoot the electrical system.
How to troubleshoot electrical problems on a motorcycle?
This page will serve as a starting guide to get you started troubleshooting electrical problems on your motorcycle. Ohmmeters/multimeters have a setting to measure the resistance between wires and electrical components. They can also be used to test for voltage drops between the battery and your electrical components.
Why does my motorcycle need an electrical connector?
Most wiring-connector problems boil down to one of two predicaments: Either something broke and needs to be repaired—perhaps a wire parted or its terminal was pulled or corroded off—or you want to add an accessory that needs to be wired into the motorcycle’s electrical system. In both instances the solution is straightforward.
The purpose of this guide is to help riders to begin the process of troubleshooting motorcycle electrical problems. You will need a multimeter and the shop manual for your specific motorcycle to troubleshoot the electrical system.
Faulty wire grounds are a very common problem, but can sometimes be difficult to track down. Symptoms of a bad ground can range from a completely dead bike to electrical components working intermittently. Checking all of the grounds on your motorcycle can be done quickly if you know where they all are.