How can you tell if a fuse is good?
The fuses inside are fed, in groups, from the larger fuses under the hood, so check those first. The large 30 and 40-amp spade-type fuses, (orange and green ones), have two test points on top. Use a test light to quickly check those. If you find twelve volts on both test points, that fuse is good.
What does no power to the fuse panel mean?
No Power to the Fuse Panel: Not Getting any Power to the Fuse Not getting any power to the fuse panel. It is the box inside the car. I think its a 3.3c.U. have the same problem? The fuses inside are fed, in groups, from the larger fuses under the hood, so check those first.
Where are the fuses in a Dodge truck?
Dodge hid one fuse that you probably missed. It’s called the ignition-off draw (IOD) fuse, located in the inside fuse box, the Junction Block. Look under the panel at the far left end of the dash… The fuse is held inside a black colored fuse holder with tabs to make it easier to pull out of the block.
Where are the fuses on my cigar lighter?
Pull the holder up, then unlatch and flip the fuse cover over to gain access to the 10-amp fuse inside. Since it also powers the cigar lighter, this is probably where it met its fate.
Where are the fuses for the dashboard lights?
Check under the hood, under the dashboard, or near or in the glove compartment. Once you find the fuse box or boxes, remove the lid and check the diagram on the underside of the lid for a fuse labeled “dash lights” or just “lights.” Refer to your owner’s manual if you have trouble locating the fuse boxes or the dashboard light fuse.
What to do if your dashboard light does not work?
A blown fuse can disable the vehicle’s dashboard light. The fuse box may be under the hood, or near the floor, near the brake pedal, or there may be two fuse boxes in both places. Refer to the diagram on the fuse box cover to locate the correct fuse. Replace the dashboard light fuse if necessary. Note: also check if the tail lights are working.
Why are all my fuses working but no power?
Wiring between the underhood fuse block (PDC) and the JB could be broken or burned up. The #12 fuse location is central to the circuit, so finding out if power is present there will tell us which way to go. Here are the other circuits the fuse feeds… just in case one or two may still operate.
What should all fuses make test light?
If the ignition switch is ON but the engine is not running, all the fuses should read about 12V or the test light should glow. The switch to turn things on is downstream of the battery and the fuse. Tail lights should be connected around the ignition switch directly to the battery so they can be turned on without the ignition being on.