Do you need to torque water pump bolts?
You shouldn’t need a torque wrench for a water pump. Just tighten the bolts tight enough so that the gasket doesn’t leak. A good practice is to not tighten the bolts in a circle pattern but in a cross pattern and tighten each gradually. Not necessary, but preferable, if you’re not used to handling a spanner.
How tight do water pump bolts need to be?
They should be tight. Use your calibrated elbow, tighten until tight, then go 1/8th turn more. Tighten both bolts evenly in progressive stages.
How do you remove a bolt you can’t reach the nut?
How to Remove a Stubborn Nut/Bolt
- Step 1: Use Some Muscle. Try a 6-point wrench or socket on your seized nut/bolt.
- Step 2: Clean It Up.
- Step 3: Leverage.
- Step 4: Heat ‘er Up.
- Step 5: Be Smooth.
- Step 6: Home Chemistry.
- Step 7: Drill a New Hole.
- Step 8: Split a Nut.
What’s the best way to replace a water pump?
Pay attention to the length of the bolts as you remove them because they might not all be the same. Use a scraper or Brillo pad to make sure all surfaces, including the pump mounting surfaces, are clean and free of old water pump gasket material and adhesives before reassembly.
Do you need to replace the tensioner on a water pump?
If the belt needs to be replaced, chances are the tensioner will as well. Test-fit the water pump and visualize assembly before proceeding. Use RTV silicone water pump gasket sealer and/or a gasket if your repair manual recommends it. Take your time with this step as leaks can result if done improperly.
How do you remove a water pump from a thermostat?
Once the hose is removed, you can unbolt the thermostat housing. Use the 10mm socket to remove the seven 10mm bolts that hold the water pump in place. Note, you may need to move the engine carrier bracket to access the water pump. Once all seven bolts are removed, pull the water pump out. Figure 7. Bolts holding the water pump. Figure 8.
Do you need to remove radiator to replace water pump?
Your vehicle’s repair manual will tell you which components you’ll need to remove to get to the car water pump. On some engines, you may need to remove the radiator, shroud and hoses to access the water pump. You may also need to remove the fan, pulleys and harmonic balancer, which will require a specialized puller.