Do you have to replace all brake rotors at the same time?
My car has an automatic transmission. Hey there. You do not need to replace all 4 rotors at the same time, but it is recommended to replace the rotors and pads as a set for each axle front or back at the same time. If the front brakes need to be replaced but the rear brakes are not worn out yet, then you do not need to replace the rear brakes.
When do I need to replace my brake pads?
A. The only time you’ll need to replace your brake pads and rotors is when the pads are worn and your rotors are warped, though that doesn’t happen often. Rotors are engineered to last about 50,000-80,000 miles for standard steel.
When do brake rotors and pads wear down?
Car weight: The heavier the car or the more upgrades or modifications added to a vehicle, the more quickly rotors and pads wear down. Axle position: The front axle usually bears more weight than the rear, as well as (typically) forward bias proportioning.
Where are the brake rotors on a car?
The brake rotors are the flat, shiny discs located behind the wheels on most cars. Each of your car’s wheels has its own brake pad and rotors. Over time, the constant friction between these two parts wears the brake pad down. The less traction it has, the less effective it is at stopping your vehicle when you need it most.
What tools do you need to change brake pads?
The tools needed to change the rear brake pads include a floor jack, two jack stands, a lug nut wrench, a 14mm socket with a 3/8″ drive ratcheting wrench, an “F” clamp and a tube of high temperature synthetic brake parts lubricant grease. The additional tools needed to replace the rear rotors include a propane blow torch,…
How do you change disc brake pads?
Take out the disc brake pads. Inspect the rotor for wear and replace, if necessary. Rotate the piston clockwise with the special tool, rear caliper piston adjuster, T87P-2588-A, until properly seated. Position one of the piston slots so it engages the brake pad’s fastener. Replace the disc brake pads with the new ones.
How do you change brakes?
Steps in Changing the Brakes Lift the car. Remove the tire. Remove any rust (if necessary). Remove the brake caliper. Clean all the old and new parts. Remove the old brake pads. Install the new brake pads. Reinstall the wheel. Tighten the lug nuts again after 25 miles.