Did Bosch buy Sunpro?
That is quite an impressive history and the formidable company BOSCH thought so too because in 2012 they purchased SUNPRO and now SUNPRO is part of the BOSCH family but that has not altered their dedication to product satisfaction and innovation.
Who makes Sunpro tach?
Accurate air core meters. 0-8,000 RPM scale, 250° dial sweep. Adjustable red line pointers. Works on 4, 6 or 8 cylinder, 12 volt negative ground engines….Part CP7901.
| Brand | Sunpro |
|---|---|
| Terminology | Tachometer Gauge |
| Dimensions | 3-3/8 in |
Who owns Sunpro?
Snap-on Corporation
Sunpro is a registered trademark of Snap-on Corporation used under license of SPX Corporation. For more than 60 years, Sunpro has meant performance with such classic products as the Sun Super Tach II, inspired by the company’s rich motorsports heritage.
Do they still make Sun tachometer?
Over the years, time passed by the vintage Sun tachometers. Sadly, they were eventually discontinued.
Where is the tachometer sensor located?
The tach sensor is located on the injection pump gear cover on the front of the engine. The part number, which includes the sensor and pigtail connector, is E5TZ-17B384-A.
Is there a fuse for the tachometer?
Check the Fuses: If you look for the fuse box in your car, find the fuse for the tachometer. If it has blown this could be the source of your problem. A blown fuse may be discoloured and could have a break in the metal strip.
What kind of wiring diagram does SunPro Super tach 2 use?
Sunpro Super Tach 2 Wiring Diagram – wiring diagram is a simplified agreeable pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the skill and signal links amid the devices.
How long does it take to install a Sunpro tachometer?
The tachometer grew in popularity in the 1960s and 1970s with the rise of sport and muscle cars. Tachometers are devices that measure the revolutions per minute (rpm) of the engine. This helps the driver monitor the vehicle and shift gears at the optimum times. Sunpro tachometers are simple to install and should take about an hour to complete.
How do you wire a Sunpro tach ring?
How to Wire a Sunpro Tach. Step 1. Connect the black wire to a clean unpainted ground using a ring terminal or other safe grounding means. Step 2. Step 3. Step 4.
How do you connect a tachometer to a battery?
To complete installation of the tachometer, feed the green and red wires through the firewall for connection to the battery and ignition coil. You should be able to do this by accessing the holes for existing wiring harnesses.