Can you replace the drive belt on a Chevy W124?
Replacing the drive belt on the W124 is a very doable DIY; what it is not is as simple as doing it on and old Chevy. To replace the belt the radiator shroud and the fan will need to be removed. While you can loosen the belt to work on the accessories with the fan still attached, you will need to remove the fan if you are replacing the belt.
What kind of belt does a 3800 V6 use?
3800 V6 Belt Routing Picture and Ro… Supercharged 3.8L V6 Drive Belt rou… Vortec 5.3 and 4.8L V8 Truck Belt R…
Do you need to remove the belt to replace the radiator?
To replace the belt the radiator shroud and the fan will need to be removed. While you can loosen the belt to work on the accessories with the fan still attached, you will need to remove the fan if you are replacing the belt. A word of caution here before you begin.
How often should I replace my drive belt?
You should check your drive belt every six months for wear, cracking, fraying, delaminating and drying out. If your belt shows any of these signs you should replace it. I recommend you buy two belts and always keep an extra one in the car. You don’t want to be stranded on the side of the road for the lack of a spare drive belt.
How do you change a ground drive belt?
Route the new ground drive belt over the cooling fans and onto the transmission pulleys. Thread the belt through the idler pulley and over the engine crankshaft pulley. Have your helper push in the idler pulley bracket while you roll the belt onto the engine pulley.
Can a drive belt be replaced on a craftsman lawn mower?
Replace the drive belt with a manufacturer-approved lawn mower part if it’s worn or broken. This drive belt replacement procedure works for common Craftsman, Toro, Troybilt, MTD, Husqvarna, Poulan, Murray and Ariens front-wheel drive walk-behind lawn mowers.
Where is the drive belt on a riding mower?
A spacer is positioned above the pulley on the crankshaft and the top edge radius matches the step on the crankshaft. Remove the lower drive belt from the mower by pulling it towards the engine. Lawn mower belt installation is essentially the removal process in reverse.
Replacing the drive belt on the W124 is a very doable DIY; what it is not is as simple as doing it on and old Chevy. To replace the belt the radiator shroud and the fan will need to be removed. While you can loosen the belt to work on the accessories with the fan still attached, you will need to remove the fan if you are replacing the belt.