Can a TJ transmission be replaced on a Jeep Wrangler?
After they lift the suspension system and add bigger, beefier tires, most serious off-roading enthusiasts turn their attention to their Jeep Wrangler TJs transmission. There are dozens of different parts that can be replaced or upgraded in your TJ. These overhauls range from minor to comprehensive.
What kind of transmission does a Jeep Grand Cherokee have?
44RE: A four speed automatic transmission was used in 1996 to 1998 Jeep Grand Cherokee’s with 5.2L engines. 42RE: A four speed automatic transmission was used in 1993.3 to 1998 Jeep Grand Cherokees with 4.0L engines.
What kind of drivetrain does a jeep TJ have?
Here’s a mini-spec list of the axles, transfer cases, engines, and transmissions that came stock in all TJ models and years. If you need to identify your axles, all the info you need is right there. The easiest way to see what kind of rear axle you have is the type of fill plug in it.
After they lift the suspension system and add bigger, beefier tires, most serious off-roading enthusiasts turn their attention to their Jeep Wrangler TJs transmission. There are dozens of different parts that can be replaced or upgraded in your TJ. These overhauls range from minor to comprehensive.
Why is my Jeep Wrangler transmission not working?
A couple of weeks ago I bought a used Jeep Wrangler (year 2000, 4.0L, automatic, 130k miles), and think there might be an issue with the auto transmission. Here’s the symptoms: · If the engine is cold (and it’s a cold day) then sometimes the transmission won’t engage.
What does 10 spline mean on Jeep Wrangler transmission?
Click to expand… The 10 spline input refers to the input shaft of the transmission that mates to the engine. Here is my NV3550 input shaft while doing a clutch replacement. And the 23 spline output refers to the rear shaft that mates to the transfer case.
What are the symptoms of TJ automatic transmission problems?
Here’s the symptoms: · If the engine is cold (and it’s a cold day) then sometimes the transmission won’t engage. E.G. Start the engine, move from Neutral to Drive, put your foot on the gas, revs increase, but the Jeep doesn’t move. Rev it a bit higher and drive will engage…
When did the first Jeep transmission come out?
Assuming your Jeep hasn’t had a different transmission swapped into it, here are the original factory transmissions produced since 1945 (manuals) and 1963 (automatics). There you have it! A chronological history of transmissions for Jeeps (for you history buffs out there).
What are the parts list for a 1999 Jeep Wrangler TJ?
Orygun, the wet side… Nice! I showed up late to the party and was going to throw the 1999 FSM and Parts list up, but it’s already there. Good show.
What is the input shaft on a Jeep Wrangler?
Here is my NV3550 input shaft while doing a clutch replacement. And the 23 spline output refers to the rear shaft that mates to the transfer case. The 10 spline input refers to the input shaft of the transmission that mates to the engine.
Assuming your Jeep hasn’t had a different transmission swapped into it, here are the original factory transmissions produced since 1945 (manuals) and 1963 (automatics). There you have it! A chronological history of transmissions for Jeeps (for you history buffs out there).
What kind of transmission does a Jeep Wrangler have?
The 42RLE is a medium duty overdrive, 4-speed, automatic transmission that lives in Wranglers born from 2003 to 2011. These transmissions feature four forward gears including one overdrive gear. With an aluminum housing, the NV1550 was a short-lived 5-speed manual transmission for Jeep Wranglers.
When to use ATF + 4 in Jeep Wrangler?
ATF+4 was developed to succeed ATF+3 applications and degrade much slower. Where a transmission with ATF+3 might experience some shudder at around the 30k mile mark, the same trans with ATF+4 shouldn’t experience shudder until 80-100k miles (depending on driving conditions). In short, ATF+4 is a complete replacement for ATF+3.