Can a 2013 Cummins ISX 12 GET OIL Milky?

Can a 2013 Cummins ISX 12 GET OIL Milky?

2013 Cummins isx 12. Getting coolant in oil. Not enough to make the oil milky but loosing coolant and oil test shows 2013 Cummins isx 12. Getting coolant in oil. Not enough to… I have a 2013 kenworth with a Cummins isx 15 automatic. Just I have a 2013 kenworth with a Cummins isx 15 automatic .

Why does my ISX motor have oil in the coolant?

Cummins ISX motor has oil in the cooling system. Oil cooler failure will not always result in coolant in the oil but always oil in the coolant. other causes of oil in the coolant are trans cooler leaking (if you have one) Bad head, head gasket The only way to check that is remove head and have it checked by a head shop.

Can a 2013 Cummins get coolant in oil?

2013 Cummins isx 12. Getting coolant in oil. Not enough to… I have a 2013 kenworth with a Cummins isx 15 automatic. Just I have a 2013 kenworth with a Cummins isx 15 automatic . Just had a new clutch put in , the old one was really bad , broken pieces everywhere , … read more I have a deleted 2013 isx 15. Pressure in coolant system and

Why is my Cummins ISX oil leaking so slow?

All around the pass through is the coolant jacket. When the engine cools down the metal contract and oil seeps through to the coolant. Once warm and the metal expands again it makes a good seal, that is why the leak into the coolant is so slow. Not that bad of a job, turbo has to come off.

Are there any common problems with Cummins ISX engines?

No all CUMMINS ISX engines are going to present all this problems but at least they are going to have one of them. This common problems are going to be similar all CUMMINS ISX engines from 2008 and up and all manufacturs: Freightliner Kenworth Volvo Peterbilt international, etc,..

Why does my ISX truck won’t start?

I took the truck to my regular mechanic to have a full service done, and after they replaced all the fuel filters, it woudln’t start over their pit. (the primer pump was whirring away everytime i turned the key to the on position) Long story short, they diagnosed it as a bad high pressure pump.