Are there any problems with the International 4300?
International 4300 owners have reported 11 electrical system related problems since 1996. Table 1 shows the 5 most common electrical system problems. The number one most common problem is related to the vehicle’s electrical system (6 problems).
What should the high pressure switch be on an international 4300?
Sounds like the high pressure switch is bad. The high side should go up close to 300psi before it cuts the compressor off. The normal opperating range for the high side is 180-250 and your not getting that.
Why is my international gauge cluster not working?
These international gauge clusters have a common problem with lights flickering or not working at all, and also with the gauges sticking, giving incorrect readings, or not working at all. Replacing the instrument cluster is not the best solution, because many of the replacement units often use the same faulty components as the original cluster.
When did the 2003 International 4300 catch fire?
The company owns a 2003 International 4300. The contact was waiting for a tire mechanic to arrive when he noticed smoke underneath the wheel of the vehicle. The vehicle caught fire on June 10, 2008 in the engine compartment, and was destroyed.
International 4300 – Automatic trans problems? International 4300 – Automatic trans problems? We have a 2002 International 4300 with the automatic trans w/ park. We have been having some really bad transmission problems with it.
What kind of transmission does a 2002 International 4300 have?
We have a 2002 International 4300 with the automatic trans w/ park. We have been having some really bad transmission problems with it. The truck will run fine for 2 days then all of the sudden the “check trans” light will come on and the truck will not shift out of low gear.
Are there any 2007 International 4300 trucks for sale?
Our company has three impact attenuator trucks for sale. All three are the same year, make, model and have similar amount of miles (268,000). These ar… 2007 INTERNATIONAL 4300, DT466, 210 HORSE POWER, FULLER 6 SPEED, 10,000# FRONT, 21,000# REAR, 2018 UNITED 2300 GALLON WATER TANK, 2 FRONT, 2 SIDE, 2 R…
Where is the harness on an international 4300?
Check the harness on the left side of the firewall under the hood . When the hood is close, it pull the harness out of the firewall giving it a bad connection at the connector.Had this problem on 3 late model 4300″s.
When was the last time IH 4900 had no power?
This topic contains 3 replies, has 2 voices, and was last updated by Brian Sanderlin 4 years, 11 months ago. So my IH 4900 was acting like it had no power towards the end of my route.
What kind of engine does a 2005 International 9200 have?
I have a 2005 International 9200 with a Cummins ISM engine. The engine runs fine but the truck has developed an instrument panel problem. The water temp, oil pressure warning lights flash, the tachometer and speedometer, the voltmeter, oil pressure gauge and water temperature gauge, each pin to the right side of each gauge.
Is there a problem with the International guage cluster module?
The international guage cluster module is famous for this issue, it’s an internal problem in the cluster module. You can purchase a new cluster module (bare shell) for about $300 from international and transfer all your guages and bulbs into the new cluster module. Thanks bender, I appreciate your input.
Why is my international dump truck not working?
The contact owns a 2005 International 4300 dump truck. The contact stated the engine would slip into idle mode and when depressing the accelerator pedal, it would not respond. The failure occurred while driving various speeds.
When does the idle shutdown warning come on?
The idle shutdown warning occurs 30 seconds before the idle shutdown timer expires (i.e. 30 seconds before shutdown). The red idle shut down indicator (if equipped) will flash in the gauge cluster for 30 seconds and an audible alarm will sound during the warning.
Why is my international 4200 VT not cranking?
I have a International 4200 that will not crank over with key. It just started and ran. Now it only energizes he starter relay and does not crank. It is not the starter because I can hot wire it and it will crank. All wiring looks good. On dash there is Check electrical system light on. I put new batteries in and all connections look good.
Can a 2005 International shut off while driving?
I have a 2005 International with a DT466. The issue I’m having is without warning, while driving down the road the truck will lose power and then shut off. No engine light comes on, no codes in the Dash changed the fuel filter checked the fuses in the battery box, Checked the relays underneath the hood and replaced the camshaft sensor.
What kind of engine does a 2005 International 4300 have?
2005 INTERNATIONAL 4300 4×2 Medium Duty 26Ft Box Truck – Good Condition – International DT466 Diesel 215 HP Engine, Allison 5 Speed Automatic Transmis… Stock #13651W2005 International 4300 25′ Flatbed Truck7.6L DT 466 Diesel Engine 220HPAutomatic Transmission151,994 Miles25,500 GVWR (NO CDL REQUIRED)
What kind of truck is the 2005 Altec international 4300?
2005 61′ ALTEC INTERNATIONAL 4300 with dump body. Truck has new transmission interior is in great condition 6 speed manual transmission. Was bought in… 2005 International 4300, LTD Miles: 214169, WHITE, Drive Axles: Single, Diesel, International, , 245, 6 SPD, Engine Brake (Y/N): Y, Rear Susp Type: Sp…
What are the problems with the Allison 4300 automatic Trans?
When the hood is close, it pull the harness out of the firewall giving it a bad connection at the connector.Had this problem on 3 late model 4300″s. I had this same problem and called the Allison shop and the guy said to wiggle the wiring harness connector on the tranny and firmly push it in.
Is the IDM on my DTC 525 bad?
It doesnt show symptoms of a fault but it has the engine light on. It turns on and runs fine. I have checked the voltage to the IDM relay and its getting 12.4. I believe next i have to check the power getting to the IDM itself before concluding the IDM is bad but I need help on this one if anyone can give me any ideas.
Is there charge for DTC 525 injector driver?
There is no charge for this service, but standard message and data rates may apply. 525 is either bad power or dirty grounds to the IDM, or a failed IDM. It is totally possible for the IDM to fail in such a way that it causes this code and check engine light, but engine runs fine.
What kind of engine does an International 4700 have?
We have a 2000 International 4700 with a DT466E Engine. The engine is new, the injectors are all new, the MAP Sensor is new, the Baro Sensor is new, the Cam Sensor is new, the High Pressure Oil Pump is new, the fuel sensor and regulators are new, the computer is new.
https://www.youtube.com/watch?v=LYFnW7s6RTE
How do you find the engine code on an IH 4300?
You then count and record the flashes of the Amber engine light. They are 3 digit codes. The code list is in the stickies I believe. A bit of a PItA but it works. To clear codes you hold the buttons, turn key on and pump throttle 3 times.
How do you clear a code on a 4300?
To clear codes you hold the buttons, turn key on and pump throttle 3 times. Well I tried it on the truck im driving. (2002 4300 dt466e) No flashes.
What kind of engine does a 2005 International 4300 DT 466 have?
Here is a little more info. 2005 international 4300 dt 466 trimmed y 225 hp. Single drive axel, 6 speed manual with air brake and air ride. I know it sounds weird, but have you checked your ride hgt?